Pasar al contenido principal

FABRICACION DE CERAMICOS ESTRUCTURALES ULTRADUROS BASADOS EN B4C CON TENACIDAD MEJORADA PARA APLICACIONES INGENIERILES DIVERSAS

MAT2016-76638-R

•
Nombre agencia financiadora Agencia Estatal de Investigación
Acrónimo agencia financiadora AEI
Programa Programa Estatal de I+D+i Orientado a los Retos de la Sociedad
Convocatoria Proyectos I+D+i Retos de Investigación
Año convocatoria 2016
Plan Estatal 2013-2016 Plan Estatal de Investigación Científica y Técnica y de Innovación
Centro beneficiario UNIVERSIDAD DE EXTREMADURA

Resultados relacionados

Resultados totales (Incluyendo duplicados): 6
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Raman characterization and photoluminescence properties of La1-xTbxPO4·nH2O and La1-xTbxPO4 phosphor nanorods prepared by microwave-assisted hydrothermal synthesis

  • Colomer, María T.
  • Bartolomé, Jose F.
  • Ortiz, A.L.
  • Andrés, Alicia de
The effect of the Tb–doping content (in the range 0–100 mol%) on the structure (using Raman spectroscopy) and photoluminescence (PL) properties of both rhabdophane-type LaTbPO·nHO and monazite-type LaTbPO single-crystal nanorods was investigated. LaTbPO·nHO was directly obtained by microwave-assisted hydrothermal synthesis and LaTbPO by calcination of LaTbPO·nHO at 700 °C in air for 2 h. It was found that the characteristic Raman bands shift to higher wavenumbers and become broader with increasing Tb concentration, which is attributed to attendant unit-cell volume reduction. The PL due to the Tb f-f transitions has been studied with continuous and pulsed excitations. The PL intensity increases with doping and is maximum for LaTbPO·nHO and LaTbPO, i.e., for rhabdophane and monazite-type structures, respectively. A quenching effect is detected for concentrations below x=0.05, but constant efficiency is obtained at higher doping. The calcination increases the efficiency by a factor around 2 due to the combined effects of water molecules and defect elimination. The PL decay curves reveal a long lifetime attributable to single Tb ions which is almost independent of doping for monazite nanorods (5–4.5 ms), and a shorter one around 0.2 ms most likely due to Tb dimmers., This work was supported by the Ministerio de Economía y Competitividad (MINECO, Government of Spain) under Grants no. MAT2012-31090, MAT2015-65356-C3-1-R, MAT2016-78700-R and MINECO and FEDER Funds under Grant no. MAT2016-76638-R. Financial support from the Comunidad de Madrid under Grant no. P2013/MIT-2740 is also acknowledged.
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

High-temperature compressive creep of novel fine-grained orthorhombic ZrO2 ceramics stabilized with 12 mol% Ta doping

  • Sponchia, Gabriele
  • Moshtaghioun, Bibi Malmal
  • Riello, Prieto
  • Benedetti, Alvise
  • Gómez-García, Diego
  • Domínguez-Rodríguez, Domingo
  • Ortiz, Ángel L.
A novel fine-grained orthorhombic ZrO2 ceramic stabilized with 12 mol% Ta doping was fabricated by spark-plasma sintering from home-made powders, and its high-temperature mechanical properties evaluated for the first time by compressive creep tests in both Ar and air. It was found that the high-temperature plasticity of the ceramic deformed in Ar, under which the Ta-doped orthorhombic ZrO2 is a black suboxide with abundant oxygen vacancies in its crystal structure, is controlled by grain boundary sliding (stress exponent ∼2, and activation energy ∼780–800 kJ/mol). However, the high-temperature plasticity of the ceramic deformed in air, under which the Ta-doped orthorhombic ZrO2 is a white oxide due to the elimination in situ of oxygen vacancies, is controlled by recovery creep (stress exponent ∼3, and activation energy ∼750 kJ/mol). It was also observed that black Ta-doped orthorhombic ZrO2 is more creep resistant than its white counterpart with the same grain size, and that the former deforms as the more conventional Y2O3-stabilized ZrO2 does., This work was supported by the Junta de Andalucía under Grant nº P12-FQM-1079 and by the Junta de Extremadura under Grant nº GR15078, co-financed with FEDER Funds. Financial support from the Ministerio de Economía y Competitividad (Government of Spain) and FEDER Funds under Grants nº MAT2015-71411-R and MAT2016-76638-R is gratefully acknowledged as well.
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

An interplay between electronic and structural effects on the photoluminescence decay mechanisms in LaPO4·: N H2O:Tb3+ and LaPO4:Tb3+ single-crystal nanorods

  • Colomer, María T.
  • Díaz-Moreno, Sofía
  • Tamayo Hernando, Aitana
  • Ortiz, A.L.
  • Chaboy, Jesús
[EN] A novel High Energy Resolution Fluorescence Detected X-ray Absorption Spectroscopy (HERFD-XAS) study at the Tb L-edge for the rhabdophane-type LaPO·nHO:Tb and the monazite-type LaTbPO:Tb nanorods is reported. We have observed that the changes in the white-line intensity follow a similar trend to that previously observed in the photoluminescence behaviour of these materials. Those changes have been assigned to the localization of the terbium 5d states and the modification induced by the hybridization with the next neighbours as the terbium content is varied. The interplay between electronic (d-state localization) and structural (local disorder) effects is used to explain the different optical behaviour between the two series of nanorods. The XAS results indicate that the local ordering is a key factor influencing the different emission efficiencies, quenching effects and decay lifetimes observed experimentally for both series of nanorods. The present results indicate that the long lifetime decay process is accounted within a standard single Tb ion scenario, where the structural disorder, favoured by the presence of water molecules in the structure, aids the non-radiative recombination processes. Implications for future use of the white-line intensity in the HERFD-XAS spectra in characterizing other luminescent materials are also discussed., The research leading to these results has been supported by the project CALIPSOplus under the Grant Agreement 730872 from the EU Framework Programme for Research and Innovation HORIZON 2020 and by the Ministerio de Economía y Competitividad (MINECO, Government of Spain) and FEDER funds under Grant no. MAT2016-78700-R and MAT2016-76638-R. We acknowledge Diamond Light Source for time on Beamline I20-Scanning under Proposal SP-15968. The authors are also grateful to Prof. A. de Andrés for her useful suggestions and to Mrs C. Díaz-Dorado for her help in the preparation of TEM and PL pictures.
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Structural-microstructural characterization and optical properties of Eu3+,Tb3+-codoped LaPO4·nH2O and LaPO4 nanorods hydrothermally synthesized with microwaves

  • Colomer, María T.
  • Zur, Lidia
  • Ferrari, Maurizio
  • Ortiz, Ángel L.
[EN] Rhabdophane-type Eu,Tb-codoped LaPO·nHO single-crystal nanorods with the compositions LaEuTbPO·nHO (x = 0–0.03), La TbEuPO·n′HO (y = 0–0.010), and LaTbEuPO·n′′HO (z = 0–0.012) were hydrothermally synthesized with microwaves. It is shown that the Eu,Tb codoping does not affect the thermal stability of these nanorods, which is due to the formation of substitutional solid solutions with both Eu and Tb replacing La in the crystal lattice. Moreover, it is also shown that monazite-type Eu,Tb-codoped LaPO single-crystal nanorods can be obtained by calcining their rhabdophane-type Eu,Tb-codoped LaPO·(n,n′ or n′′)HO counterparts at moderate temperature in air, and that they are thermally stable. It is also observed that, for the same Eu,Tb-codoping content, the monazite-type Eu,Tb-codoped LaPO nanorods exhibit higher photoluminescent efficiency than the rhabdophane-type Eu,Tb-codoped LaPO· (n,n′ or n′′)HO nanorods. Moreover, it is found that the highest photoluminescence emission corresponds to the monazite-type LaEuTbPO nanorods for the La EuTbPO system. However, for those compositions energy transfer from Tb to Eu does not occur. In addition, for an efficient energy transfer to occur, a content of at least 1 mol% Tb is needed in all the studied materials., This work was supported by the Ministerio de Economía y Competitividad (MINECO, Government of Spain) under Grant no. MAT2016-78700-R. The authors also acknowledge Consiglio Nazionale delle Ricerche-CNR for funding through the Short-Term-Mobility (STM) Program. ALO also thanks the MINECO and FEDER funds for granting the project MAT2016-76638-R. The authors are in debt with Dr. J.J. Reinosa and Ms. C. Álvarez-Docio for the PL measurements under 345 nm of selected samples. The authors also acknowledge to Mrs. C. Díaz-Dorado for her help in the preparation of some figures.
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Processing and electrical conductivity of non-stoichiometric lanthanum strontium manganite perovskites prepared from powders synthesized by a polymerizable-complexation route

  • Colomer, María T.
  • Chinarro Martín, Eva
  • Ortiz, Ángel L.
[EN] Perovskite ceramics with non-stoichiometric compositions given by (LaSr)MnO ((LS)M-85) and (LaSr)MnO ((LS)M-80) were obtained by pressureless sintering (1500 °C for 2 h) from powders synthesized by a polymerizable-complexation route and then calcined (500 °C for 1 h). It was found that the two sintered ceramics contain trigonal (i.e., R3̅c) Sr-doped lanthanum manganite as majority phase, and also hexagonal (i.e., P6/m) La(OH) in trace amounts in the case of (LS)M-85 and in abundant amounts in the case of (LS)M-80. The (LS)M-85 ceramic is stable and therefore usable, whereas on the contrary the (LS)M-80 ceramic eventually swelled and turned into a powder due to the abundant La(OH) that uptakes water from the atmosphere. Finally, it was found that the (LS)M-85 ceramic has appropriate electrical properties for use as cathode in solid oxide fuel cells, with a total conductivity of ~ 145 S/cm at 1000 °C and an activation energy of 0.067(2) eV., This work was supported by MINECO (Government of Spain) and Feder Funds under Grants no. MAT2016-78700-R, MAT2016-76638-R and ENE2013-49111-C2-1-R. The authors also acknowledge to Mrs. M. Fernández and Mrs. R. Navidad for their experimental help, and to Mrs. C. Díaz-Dorado for her help in the preparation of figures.
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Influence of Nd3+ Doping on the Structure, Thermal Evolution and Photoluminescence Properties of Nanoparticulate TiO2 Xerogels

  • Colomer, María T.
  • Roa, Carlos
  • Ortiz, Ángel L.
  • Ballesteros, Luz M.
  • Molina, Pablo
[EN] Undoped and Nd-doped xerogels (Nd-dopant content in the range 0.5–10 mol%) were obtained from colloidal sols in turn prepared by a “green sol-gel route” in aqueous media. The as-synthesized xerogels were characterized by X-ray diffractometry (XRD), high resolution electron microscopy (HREM) together with selected area electron diffractometry (SAED), and Raman spectroscopy (RS), finding that they crystallize as tiny nanocrystals of anatase with traces of brookite and rutile. The thermal stability of the as-synthesized xerogels was next studied in-situ by X-ray thermo-diffractometry (XRTD) as well as ex-situ by XRD, HREM/SAED, and RS on xerogels calcined at different temperatures (400–900 °C), concluding that Nd doping results in the formation of substitutional solid solutions with enlarged unit-cell volume that (i) stabilizes the anatase phase retarding the onset of its transformation to rutile to ever higher temperatures and (ii) provides the anatase nanocrystals with superior resistance to crystal growth. It was also found that NdTiO eventually precipitates at high temperatures when the Nd-dopant content is equal to or higher than 3 mol%, which leaves the still-existing anatase nanocrystals without stabilizer cations therefore causing their immediate transformation to rutile. Finally, the photoluminescence (PL) behaviour of the Nd-doped TiO xerogels with both anatase and rutile crystal structures was investigated and critically compared, observing that the PL emission (i) increases with increasing crystallinity of the host nanocrystals, (ii) decreases above a certain optimal Nd-dopant content due to concentration quenching, and (iii) is much greater for rutile host matrices. In this scenario, the 3 mol% Nd-doped rutile xerogel maximized the PL emission, emitting at both ∼915 and 925 nm due to the existence of two distinct local crystal fields for the Nd cations., This work was supported by the Ministerio de Economía y Competitividad (Government of Spain) and FEDER Funds under the Grants nº MAT2016-76638-R, MAT2015-67586-C3-2-R, and MAT2016-78700-R.