Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 6
Encontrada(s) 1 página(s)

Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Dependence of the Fluidizing Condition on Operating Parameters for Sorption-Enhanced Methanol Synthesis Catalyst and Adsorbent

  • Renda, Simona
  • Lasobras, Javier
  • Soler, Jaime
  • Herguido, Javier
  • Menéndez, Miguel
The fluidization of two different solids was investigated by varying the temperature and pressure conditions and the fluidizing gas. The solids are a novel catalyst and a water sorbent that could be used to perform sorption-enhanced methanol synthesis; the operating conditions were selected accordingly to this process. The aim of this investigation was to find an expression for predicting the minimum fluidization conditions of a methanol synthesis catalyst and an adsorbent in the presence of their process stream and operating conditions. The findings of this study highlighted how umf (STP) decreases with a rise in temperature and increases with a rise in pressure, according to other works in the literature with different solids. Furthermore, the type of gas was found to influence the minimum fluidization velocity significantly. The experimental results agreed well with a theoretical expression of the minimum fluidization velocity adjusted for temperature, pressure, and viscosity. The choice of the expression for viscosity calculation in the case of gas mixtures was found to be of key importance. These results will be useful for researchers aiming to calculate the minimum fluidization velocity of a catalyst or other solids under reaction conditions using results obtained at ambient conditions with air or inert gas.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

A preliminary assessment of sorption-enhanced methanol synthesis in a fluidized bed reactor with selective addition/removal of the sorbent

  • Menéndez, Miguel
  • Ciércoles, Raúl
  • Lasobras, Javier
  • Soler, Jaime
  • Herguido, Javier
Methanol synthesis from CO2 can be made in the presence of a sorbent to increase the achievable yield. If the fresh sorbent is continuously fed to a fluidized bed and separated from the catalyst bed by segregation, a steady-state operation can be achieved. The objective of the present work is to provide insight on the suitable operating conditions for such a fluidized bed reactor system. For this, a conventional CuO/ZnO/Al2O3 was selected as the catalyst, and the SiOLITE® zeolite was selected as the sorbent. Different particle sizes were used to be tested in various proportions to perform the fluidized bed segregation study. The fluid dynamics and segregation of the catalyst–sorbent binary mixtures were the most critical points in the development of this proof of concept. A good bed segregation with a mixing index of 0.31 was achieved. This fact favors the correct operation of the system with the continuous addition of adsorbent, which had hardly any catalyst losses during the tests carried out, achieving a loss of 0.005 g/min under optimal conditions. Continuous feeding and removal of sorbent with a low loss of catalyst was observed. Reactor simulations with MATLAB provided promising results, indicating that the addition of sorbent considerably improves the methanol yield under some operating conditions. This makes it more viable for industrial scaling, since it allows us to considerably reduce the pressure used in the methanol synthesis process or to increase the yield per step, reducing the recirculation of unconverted reactants.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Proof of concept for a sorption-enhanced reactor with continuous sorbent feeding (CSF): application to green methanol production

  • González-Pizarro, R.
  • Lasobras, J.
  • Soler, J.
  • Herguido, J.
  • Menéndez, M.
A new reactor for process intensification using sorption enhanced reaction is described. The novelty compared with most experimental work is that a continuous sorbent feeding (CSF) provides a steady state operation. The sorbent increases the reaction rate of a reversible reaction. The reactor is based on the phenomena of segregation of solids in fluidized bed reactors by using a catalyst and a sorbent. Under certain conditions of density and particle size, the two solids segregate and the sorbent may be removed from the bed with only a small content of catalyst. The system has been experimentally tested in the hydrogenation of CO2 to methanol, using a zeolite as sorbent. A significant increase in CO2 conversion was achieved compared with the same reactor without sorbent.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Tuning e-fuel selectivity in sorption-enhanced CO2 hydrogenation over In2O3/ZrO2: The effect of LTA and FAU zeolites

  • González-Pizarro, R.
  • Calero-Berrocal, R.
  • Lasobras, J.
  • Renda, S.
  • Rodríguez-Pardo, M.R.
  • Soler, J.
  • Menéndez, M.
  • Herguido, J.
The e-fuels synthesis via CO2 hydrogenation and the Sorption Enhanced Reaction technology are captivating strategies for CO2 utilization and the integration of renewable energy sources. This study focuses on enhancing the conversion of CO2 over an In2O3/ZrO2 catalyst by incorporating LTA zeolites (3A and 4A) and a FAU zeolite (13X). Key operational parameters, such as temperature (T), Gas Hour Space Velocity (GHSV), type of zeolite, and Zeolite: Catalyst mass ratio (Z/C), were systematically varied. LTA zeolites (3A and 4A) provided the highest CO2 conversions. The introduction of a water-adsorbing solid into the reactor significantly altered the products yield and selectivity. While the selectivity towards CH4, CH3OH, and C2H6O appeared to lay on the type of zeolite, the selectivity towards CO remained unaffected. Zeolite 3A demonstrated the greatest enhancement in selectivity towards CH4 and CH3OH, whereas the synthesis of C2H6O was favored by zeolites 4A and 13X. The Zeolite:Catalyst mass ratio also played a crucial role in process performance, influencing both CO2 conversion and product selectivity. Increasing this ratio improved CO2 conversion and reduced CO selectivity under all operating conditions, while CH4 selectivity increased. However, the selectivity toward CH3OH and C2H6O exhibited an anomalous and complementary behavior. While a maximum was observed for DME, a minimum was registered in methanol production, suggesting a dependency of the dehydration reaction kinetics on the amount of water produced during the reaction.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Low loading copper-based catalysts for effective CO2 hydrogenation to methanol

  • González-Pizarro, R.
  • Renda, S.
  • Lasobras, J.
  • Soler, J.
  • Menéndez, M.
  • Herguido, J.
Methanol synthesis via CO2 hydrogenation is an emerging Power-to-Liquid (PtL) technology aimed to accelerate the energy transition and the defossilization of key sectors, particularly maritime transport. This study focuses on the study of low loading formulations, to minimize the catalyst cost. Key operational variables including temperature (T), Weight Hourly Space Velocity (WHSV), copper and zinc loadings, and aging state were systematically varied. An overall active phase loading of 10 %wt emerged as optimal. Within this total loading, a 5 %wtCu-5 %wtZn/ZrO2 catalysts delivered higher methanol productivity than 10 %wtCu/ZrO2; however, the bimetallic catalysts showed pronounced deactivation under water-rich atmospheres, establishing 10 %wtCu/ZrO2 as the most promising catalysts. Operating temperature and WHSV exerted a strong, synergistic influence on CH3OH formation; in particular, increasing WHSV shifted the reaction away from thermodynamic control and boosted methanol synthesis. Finally, the catalytic performance of these low-loading catalysts was benchmarked against high-copper-loading methanol catalysts reported in the literature by critically compare their activities as a function of the residence time (τ) calculated at reaction conditions. This assessment revealed that the proposed formulation is highly competitive when compared to most conventional formulation, with a maximum methanol space time yield (STYCH3OH) of 3.9 gCH3OH gCu-1 h-1. This comparison confirms that the catalysts proposed in this study could offer a remarkably more efficient use of the active phase than the conventional high-copper-loading catalysts.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Overcoming thermodynamic limitations of the low-temperature reverse water-gas shift in a sorption-enhanced fluidized bed reactor with continuous sorbent feeding and separation (SEFBR + CSF)

  • González-Pizarro, R.
  • Lasobras, J.
  • Renda, S.
  • Soler, J.
  • Menéndez, M.
  • Herguido, J.
This work presents a novel approach for intensifying the reverse water gas shift (rWGS) reaction by integrating an advanced fluidized-bed reactor design with a continuous solid sorbent feeding/separation strategy. The proposed Sorption Enhanced Fluidized Bed Reactor combined with Continuous Sorbent Feeding and Separation (SEFBR + CSF) enables continuous operation while maintaining the intensification effect traditionally associated with temporal-limited sorption-enhanced processes. This configuration externalizes the regeneration of the water-adsorbing zeolite, which is continuously and selectively withdrawn from the reactor in a partially or fully saturated state and replaced with regenerated material, thereby sustaining the sorption capacity throughout operation. Process intensification was experimentally demonstrated in the SEFBR + CSF configuration, which achieved CO yields significantly higher than those obtained in the conventional fluidized-bed reactor (cFBR). During the interval in which continuous sorbent feeding was applied, CO production surpassed the thermodynamic equilibrium limit at operating temperatures between 260 and 300 °C. When compared with literature data under similar conditions, the proposed system exhibited superior CO yields, particularly in the low-temperature regime where conventional LT-rWGS performance is typically limited. Overall, the SEFBR + CSF system represents a promising pathway for continuous sorption-enhanced operation, providing improved efficiency and enabling the process to exceed the equilibrium constraints of the LT-rWGS reaction.