Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 5
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Direct measurement of the extinction coefficient by differential transmittance

  • Larruquert, Juan Ignacio
  • Gutiérrez-Luna, Nuria
  • Honrado-Benítez, Carlos
  • López-Reyes, Paloma
  • Ríos-Fernández, Álvaro
  • Pérez-García, Manuel
  • Rodríguez-de Marcos, Luis V.
15 pags., 8 figs., 1 tab., A new procedure to measure the extinction coefficient k of film materials that are relatively transparent is presented. This procedure does not require the use of an optical-constant model or the knowledge of extra physical properties of the material, such as the specific heat capacity. It involves preparing a sample with two areas, at least one of them coated with the film, whereas the other may remain uncoated or may be coated with a different thickness of the same material. The differential transmittance between the two sample areas is shown to be proportional to k of the film material in the following measurement conditions: the incident light is p polarized and it impinges at the film material Brewster angle. The differential transmittance is obtained with a single measurement by making the light beam or the sample to oscillate with respect to one another and by using a lock-in amplifier; for normalization purposes, the transmittance in one of the sample areas is also measured. The proportionality factor between the normalized differential transmittance and k only involves the wavelength, the film thickness, and the Brewster angle. The knowledge of the film Brewster angle requires that the film refractive index (n) is measured beforehand; this can be performed with standard procedures, such as ellipsometry, since such techniques are efficient at measuring n of a transparent material, but are inefficient at measuring a small k. The procedure is exemplified with the calculation of k in the far ultraviolet of AlF3 films deposited by evaporation. The dependence of the uncertainty of k obtained with this procedure is analyzed in terms of the uncertainty of the film n, of wavelength, and of the degree of polarization of the incident beam. The selection of a substrate with similar n to the film material is also discussed. The uncertainties involved with the present procedure were analyzed for a specific example and an uncertainty of 2 × 10-5 in k calculation is considered feasible., NGL acknowledges, for her technician position, the grant PTA2021-019935-I funded by MCIN/AEI/ 10.13039/501100011033 and by ESF Investing in your future. Grant PDC2022-133788-I00 funded by MCIN/AEI/ 10.13039/501100011033 and by the European Union NextGenerationEU/PRTR. Grant PID2019-105156GBI00 funded by MCIN/AEI/10.13039/501100011033. LRM acknowledges the support received from the CRESST II cooperative agreement supported by NASA under award number 80GSFC21M0002. A patent application with the procedure here presented was filed to Spanish Oficina Española de Patentes y Marcas in 2021 under No. 202130475., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Unveiling the effects of the surface and in-depth nanostructure on the far-UV optical reflectance of thin fluoride multilayer coatings

  • López-Reyes, Paloma
  • Enríquez-Pérez, Esther
  • Crespillo, M. L.
  • Rodríguez-de Marcos, L. V.
  • Olivares Villegas, José
  • Larruquert, Juan Ignacio
14 pags., 9 figs., 6 tabs., Developing high-quality optical components for far ultraviolet (FUV) spectrum is gaining significance in space observations. Optical elements designed for a narrowband FUV response rely on coatings made of thin multilayers (MLs), alternating between two materials with low optical absorption and significantly contrasting refractive indices. Recent research shows that (AlF3/LaF3) systems outperform (MgF2/LaF3) coatings in FUV optical reflectance due to two critical factors: 1) AlF3′s lower refractive index compared to MgF2, and 2) structural properties resulting from a trade-off between the number of bilayers, contributing to higher reflectance, and the tendency for roughness to increase with the total coating thickness, limiting FUV optical performance. This study conducts a comprehensive examination of the nano-microstructure of these MLs, using three techniques: AFM for surface characterization, cross-sectional SEM micrographs with backscattered electrons, and Rutherford Backscattering Spectrometry (RBS) for in-depth structural and compositional analysis. A strong correlation is observed between roughness, grain size, composition, and intermixing, impacting the optical response in the FUV range. Nanometer-scale intermixing between layers is estimated using RBS. These findings provide a foundation for modeling FUV optical reflectance in MLs, enabling the optimization of their design through materials engineering to achieve more efficient optical devices for FUV applications in space observations., The authors would like to acknowledge the funding from the regional government of Madrid through the TechnoFusion (III)-CM (S2018/EMT-4437) program, co-financed with Structural Funds (ERDF and ESF), and from the Grant PDC2022-133788-I00 funded by MCIN/AEI/ 10.13039/501100011033 and by the European Union extGenerationEU/PRTR, and Grant PID2019-105156 GB-I00 funded by MCIN/AEI/10.13039/501100011033. P.L.R. acknowledges support from Agencia Estatal de Investigacion (BES-2017-081909, Grant PID2019-105156 GB-I00 funded by MCIN/AEI/10.13039/501100011033 and by ERDF A way of making Europe). P.L.R. acknowledges R. Álvaro and “Instituto de micro y nanotecnología” (CSIC) for AFM and SEM/BSE measurements. M.L.C. acknowledges financial support from the research project “Captacion de Talento UAM” Ref: #541D300 supervised by the Vice-Chancellor of Research of Universidad Autonoma de Madrid (UAM). L.R.M. acknowledges the support of CRESST II cooperative agreement, which is supported by NASA under award number 80GSFC21M0002. The authors acknowledge the support from The Centro de Microanalisis de Materiales (CMAM)-Universidad Autónoma de Madrid, for the beam time proposal (Interface abruptness evaluation on MgF2/LaF3 and AlF3/LaF3 vacuum UV multilayers using IBA techniques) with code STD012/23, and its technical staff for their contribution to the operation of the accelerator., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Formation of hollow silver nanoparticles under irradiation with ultrashort laser pulses

  • Sánchez-Pérez, F.
  • Borrell-Grueiro, O.
  • Casasnovas-Melián, A.
  • Ramos-Ramos, D.J.
  • Guerrero-Martínez, A.
  • Bañares, Luis
  • Prada, A.
  • Valencia, F.J.
  • Kohanoff, J.
  • Crespillo, M.L.
  • Olivares Villegas, José
  • Rivera, A.
  • Peña-Rodríguez, O.
9 pags., 5 figs., We have studied the formation of cavities in spherical silver nanoparticles embedded in silica, irradiated with fs laser pulses that produce an intense electronic excitation. Experimentally determined aspect ratio, i.e. the ratio between the cavity and nanoparticle size, for hollow structures formed under different irradiation conditions shows a very good agreement with values obtained by means of atomistic simulations. According to the predictions of the atomistic model, one can produce at will hollow silver nanoparticles with cavities of tailored dimensions, having an accurate control. Hence, laser irradiation can be used to control and design the optical response by tuning the localized surface plasmon resonances of the hollow nanoparticles., This work was partially funded by the regional government of Madrid through the TechnoFusion (III)-CM (S2018/EMT-4437) program, co-financed with Structural Funds (ERDF and ESF) and by the Projects PID2019-105325RB-C32 (Radiafus-5), PID2019-105156GB-I00, PID2021- 123228NB-I00 and PDC2022-133788-I00, funded by the Ministerio de Ciencia e Innovación of Spain. This work has also been partially funded by the Eurofusion consortium (EH150531176). JK was supported by the Beatriz Galindo Program (BEAGAL18/00130) from the Ministerio de Educación y Formación Profesional of Spain. This work was partially funded by Comunidad de Madrid through the Convenio Plurianual with Universidad Politécnica de Madrid in its line of action Apoyo a la realización de proyectos de I + D para investigadores Beatriz Galindo, within the framework of V PRICIT (V Plan Regional de Investigación Científica e Innovación Tecnológica). AP and FJV were supported by FONDECYT grant 3190123. MLC was supported by the research project “Captación de Talento UAM” Ref: #541D300 supervised by the Vice-Chancellor of Research of Universidad Autónoma de Madrid (UAM). The research leading to this result has been supported by the RADIATE project under the Grant Agreement 824096 from the EU Research and Innovation programme HORIZON 2020., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Far UV coatings for liquid-Ar time projection chambers

  • Larruquert, Juan Ignacio
  • López-Reyes, Paloma
  • Gutiérrez-Luna, Nuria
  • Honrado-Benítez, Carlos
  • Pesudo, V.
8 pags., 3 figs., 1 tab. -- Light Detection In Noble Elements (LIDINE 2023), Madrid, Spain, 20–22 September 2023, Liquid Ar (LAr) and liquid Xe (LXe) time projection chambers (TPCs) are used for many applications in neutrino physics and direct dark matter searches. The performance of these detectors, particularly dual-phase ones, depends very strongly on the efficiency for detecting the far ultraviolet (FUV) scintillation light. Such detection is particularly challenging for LAr, in which the strongest scintillation feature is observed at a wavelength of 127 nm (175 nm for LXe). The current mainstream approach is covering the optical surfaces with a wavelength shifter, which absorbs de FUV light and emits at wavelengths that overlap with the optical band, where commercial devices have higher detection efficiency. This work presents coatings designed to enhance the optical properties of the detector materials and to be an alternative to the current technique. In particular, two possible coatings are proposed: narrowband and broadband FUV reflective coatings. The narrowband coatings are tuned at the FUV scintillation light. They provide a large reflectance at the design angle; additionally, these coatings are naturally transparent at longer wavelengths, which might be useful to selectively detect the wavelength of interest. Their performance is evaluated taking into account the refractive index of LAr and as a function of the angle of incidence. The same calculations are performed for an aluminium-based broadband mirror. Finally, the effect on reflectance of submerging both sorts of mirrors at liquid nitrogen temperature is presented., We acknowledge funding to Grant PDC2022-133788-I00 (MCIN/AEI/10.13039/501100011033, European Union NextGenerationEU/PRTR), Grant PID2019-105156GB-I00 (MCIN/AEI/10.13039/501100011033), Grant PID2019-109374GB-I00 and the “Atraccion de Talento” grant 2018-T2/TIC10494.
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Real‑time ionoluminescence as a probe of ion irradiation damage in monazite ceramics

  • Marín Cortés, Sonia
  • Crespillo, Miguel L.
  • Valls-Vicent, F.
  • Mariscal, A.
  • Fernández Lozano, José Francisco
  • Peña-Rodríguez, O.
  • Olivares, J.
  • Enríquez, E.
Advanced ceramics are being developed as durable alternatives to conventional matrices for immobilizing high-level nuclear waste. Rare-earth monazite-type ceramics (REPO₄), particularly EuPO₄, are promising due to their chemical durability, thermal stability, and actinide incorporation capacity. In this study, single-phase EuPO₄ was synthesized via a scalable sintering route and irradiated with high-energy 50 MeV I, 20 MeV C, and 12 MeV Si ions over a wide fluence range covering a broad range of electronic and nuclear stopping powers, to assess radiation tolerance and sensing capability. Structural and optical analyses (XRD, Raman, PL, and in situ ionoluminescence) revealed strong correlations between damage and luminescence. Carbon ions induced partial recrystallization and enhanced emission, while iodine and silicon caused greater damage and altered Eu³ ⁺ transitions. These results position EuPO₄ as both a robust nuclear waste host and a real-time optical sensor for radiation-induced structural degradation in nuclear storage environments, potentially mitigating containment failure and leakage., The authors acknowledge the Grants PDC2022–133788-I00 and PID2022–142417OB-I00 funded by MCIN/AEI/ 10.13039/501100011033 and the support from Centro de Microanálisis de Materiales (CMAM)-Universidad Autónoma de Madrid, for the beam time proposal with code IMP011/23, and its technical staff for their contribution to the operation of the accelerator. M.L.C. acknowledges financial support from the research project “Captacion de Talento UAM” Ref: #541D300 supervised by the Vice-Chancellor of Research of Universidad Autónoma de Madrid (UAM)., Peer reviewed