DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación
Artículo científico (JournalArticle)
LitMod2D_2.0: An Improved Integrated Geophysical-Petrological Modeling Tool for the Physical Interpretation of Upper Mantle Anomalies
LitMod2D_2.0 can be downloaded from https://doi.org/10.20350/digitalCSIC/9063 or GitHub https://github.com/ajay6763/LitMod2D_2.0_package_dist_users., LitMod2D integrates geophysical and petrological data sets to produce the thermal, density, and seismic velocity structure of the lithosphere and upper mantle. We present a new LitMod2D_2.0 package with improvements focused on (i) updated anelastic attenuation correction for anharmonic seismic velocities, (ii) chemical composition in the sublithospheric mantle, and (iii) incorporation of sublithospheric mantle anomalies. Sublithospheric mantle anomalies can be defined with different chemical composition, temperature, seismic velocities, and a combination of them, allowing the application of LitMod2D_2.0 to regions affected by mantle upwelling, subduction, delamination, and metasomatism. We demonstrate the potential application of LitMod2D_2.0 to such regions and the sensitivity of thermal and compositional anomalies on density and seismic velocities through synthetic models. Results show nonlinearity between the sign of thermal and seismic velocity anomalies, and that S wave velocities are more sensitive to temperature whereas P wave velocities are to composition. In a synthetic example of subduction, we show the sensitivity of sublithospheric mantle anomalies associated with the slab and the corner flow on surface observables (elevation, geoid height, and gravity anomalies). A new open-source graphic user interface is incorporated in the new package. The output of the code is simplified by writing only the relevant physical parameters (temperature, pressure, material type, density, and seismic velocities) to allow the user using predefined post-processing codes from a toolbox (flexure, mineral assemblages, synthetic passive seismological data, and tomography) or designing new ones. We demonstrate a post-processing example calculating synthetic seismic tomography, Rayleigh surface-wave dispersion curves, and P wave receiver functions from the output file of LitMod2D_2.0. © 2020. The Authors., This work has been supported by EU Marie Curie Initial Training Network (SUBITOP) (674899-SUBITOP-H2020-MSCA-ITN-2015), the Agencia Estatal de Investigación through projects MITE (CGL2014-59516) and GeoCAM (PGC2018-095154-B-100), and the Agency for Management of University and Research Grants of Catalonia (AGAUR-2017-SGR-847). Thermodynamic databases used can be found in cited references (Afonso & Zlotnik,?2011; Stixrude & Lithgow-Bertelloni,; Xu et al.,). We thank two anonymous reviwers for insightful comments and suggestions on an earlier version of this manuscript. We also thank F. Salajeghegh for sharing his GUI matlab routines. This work has been done using the facilities of the Laboratory of Geodynamic Modeling from ICTJA-CSIC. JCA's work is supported by ARC Linkage Project LP170100233 and ARC Discovery Project DP190102940. LitMod2D_2.0 can be downloaded from https://doi.org/10.20350/digitalCSIC/9063 or GitHub https://github.com/ajay6763/LitMod2D_2.0_package_dist_users., Peer reviewed