Pasar al contenido principal

DISPOSITIVOS Y SISTEMAS FOTONICOS SENSORES PARA ESTRUCTURAS INTELIGENTES Y EVALUACION NO DESTRUCTIVA I

PID2019-107270RB-C21

•
Nombre agencia financiadora Agencia Estatal de Investigación
Acrónimo agencia financiadora AEI
Programa Programa Estatal de I+D+i Orientado a los Retos de la Sociedad
Convocatoria Proyectos de I+D+i (Generación de Conocimiento y Retos Investigación)
Año convocatoria 2019
Plan Estatal 2017-2020 Plan Estatal de Investigación Científica y Técnica y de Innovación
Centro beneficiario UNIVERSIDAD DE CANTABRIA

Resultados relacionados

Resultados totales (Incluyendo duplicados): 5
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Cross Sections for Electron Scattering from Cadmium: Theory and Experiment

  • Marinković, B. P.
  • McEachran, R. P.
  • Fursa, D. V.
  • Bray, I.
  • Umer, H.
  • Blanco, F.
  • García, Gustavo
  • Brunger, M. J.
  • Campbell, L.
  • Jones, D. B.
12 pags., 5 figs. -- This paper is dedicated to Professor Michael Brunger, who coordinated the collaborative contributions, Results from the application of optical potential, relativistic optical potential, relativistic convergent close-coupling, and binary encounter Bethe models to electron scattering from gas-phase cadmium are presented. In particular, integral cross sections for elastic scattering, summed discrete electronic-state excitation, and ionization scattering processes are reported over an extended incident electron-energy range. Total cross sections are constructed by taking their sum. Measurements are presented for elastic scattering and for excitation to the 51P1 state. The theoretical and experimental results are compared to previous calculations and measurements. Recommended electron cross-section datasets are constructed over an incident electron energy range of 0.01-10 000 eV., This work was financially supported, in part, by the Australian Research Council (ARC) DP180101655, DP190100696, and DP220101480 projects; in part, by the Institute of Physics University Belgrade, through the grant by the Ministry of Education, Science and Technological Development of the Republic of Serbia (Grant No. 451-03-9/2021-14); in part, by the Spanish Ministry of Science and Innovation (Project Nos. PID2019-10727RB-C21 and C22); and, in part, by resources provided by the Pawsey Supercomputing Centre with funding from the Australian Government and the Government of Western Australia. D.B.J. is the recipient of an ARC Future Fellowship (Grant No. FT210100264) funded by the Australian Government., Peer reviewed
Dipòsit Digital de Documents de la UAB
Publicación Artículo científico (JournalArticle)

Comparison of light capturing approaches in Laser-Induced Breakdown Spectroscopy (LIBS) for multichannel spectrometers

  • Fernández-Manteca, María Gabriela|||0000-0002-7605-5409
  • Martínez-Minchero, Marina
  • García Escárzaga, Asier|||0000-0002-3625-0824
  • Ocampo-Sosa, Alain A.|||0000-0002-9104-3115
  • Mirapeix, Jesús|||0000-0002-6035-0139
  • Valdiande, José J.
  • López-Higuera, José Miguel|||0000-0002-8615-8487
  • Rodríguez-Cobo, Luis|||0000-0002-2068-2956
  • Cobo, Adolfo|||0000-0003-1498-9238
LIBS technique requires the spectroscopic analysis of the light emitted by a laser-induced plasma plume. One challenge of the different approaches to capture the plasma light emission is the significant shot-to-shot variations of the plume inhomogeneities, position, and morphology. This is even more challenging when multichannel CCD spectrometers are used, because the light should be homogeneously divided among multiple capturing optical fibers (typically up to 8 fibers) with stable spectral efficiency for all channels. Otherwise, any further analysis of the atomic emission spectra involving multiple channels, such as line intensity ratios, Boltzmann plots, or calibration-free LIBS, could be compromised by the morphology-dependent spectral artifacts induced by the collection optics. In this work, we assess the performance of several collection optics in terms of overall capturing efficiency and channel-to-channel variations due to changes in plasma morphology. Results clearly show that this could be an issue even with the approaches with the best spatial homogenization, including optical fibers and Köhler optics.
Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publicación Artículo científico (JournalArticle)

C and L band fiber lasers enhanced by ultrafast laser inscribed artificial backscatter reflectors

  • Pérez Herrera, Rosa Ana
  • Roldán Varona, Pablo
  • Sánchez González, Arturo
  • Rodríguez Cobo, Luis
  • López Higuera, José Miguel
  • López-Amo Sáinz, Manuel
This letter presents an experimental comparison between two linear-cavity erbiumdoped fiber lasers (EDFL) assisted by two different artificial backscatter fiber-based reflectors. Both reflectors were inscribed by femtosecond laser direct writing, one of them within a single-mode fiber (SMF) and the other one within a multi-mode fiber (MMF). Although the erbium-doped fiber amplifier (EDFA) used in both structures was the same and both reflectors were manufactured under the same parameters, the reflection spectrum of each was clearly different due to their different physical properties. The first linear-cavity EDFL, consisting of an SMF-based reflector with 9µm core and 125µm cladding, resulted in a single laser emission line located in the C-band and centered at 1564.4 nm, exhibiting an optical signal-to-noise ratio (OSNR) of 52dB when pumped at 100mW. On the other hand, a single laser emission line with a similar OSNR but in L-band (centered at 1574.5nm) was obtained when using an MMF-based reflector with 50µm core and 125µm cladding., Ministerio de Educacion, Cultura y Deporte (PhD grant FPU2018/02797); European Commission (Next generation EU/PTR); FEDER (A way to make Europe); MCIN/AEI/10.13039/501100011033 (PDC2021-121172-C21, PID2019-107270RB).
Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publicación Artículo científico (JournalArticle)

Method to use transport microsimulation models to create synthetic distributed acoustic sensing datasets

  • Robles Urquijo, Ignacio
  • Benavente, Juan
  • Blanco García, Javier
  • Diego González, Pelayo
  • Loayssa Lara, Alayn
  • Sagüés García, Mikel
  • Rodríguez Cobo, Luis
  • Cobo, Adolfo
This research introduces a new method for creating synthetic Distributed Acoustic Sensing (DAS) datasets from transport microsimulation models. The process involves modeling detailed vehicle interactions, trajectories, and characteristics from the PTV VISSIM transport microsimulation tool. It then applies the Flamant-Boussinesq approximation to simulate the resulting ground deformation detected by virtual fiber-optic cables. These synthetic DAS signals serve as large-scale, scenario-controlled, labeled datasets on training machine learning models for various transport applications. We demonstrate this by training several U-Net convolutional neural networks to enhance spatial resolution (reducing it to half the original gauge length), filtering traffic signals by vehicle direction, and simulating the effects of alternative cable layouts. The methodology is tested using simulations of real road scenarios, featuring a fiber-optic cable buried along the westbound shoulder with sections deviating from the roadside. The U-Net models, trained solely on synthetic data, showed promising performance (e.g., validation MSE down to 0.0015 for directional filtering) and improved the detectability of faint signals, like bicycles among heavy vehicles, when applied to real DAS measurements from the test site. This framework uniquely integrates detailed traffic modeling with DAS physics, providing a novel tool to develop and evaluate DAS signal processing techniques, optimize cable layout deployments, and advance DAS applications in complex transportation monitoring scenarios. Creating such a procedure offers significant potential for advancing the application of DAS in transportation monitoring and smart city initiatives., This research was funded by the Spanish Goverment 'Subprograma Ayudas Predoctorales 2020 Investigadores' program under Grant PRE2020-096336, assigned to the National Plan project PID2019-107270RB-C21, 'Photonic Devices and Systems Sensors for Intelligent Structures and Non Destructive Evaluation I'; the National 'Knowledge Generation Projects' project 'Photonic Sensors for Smart and Sustainable Cities (Performance)' under grant ID6448137269-137269-4-22; the project 'Integrated System for Traffic and Road Condition Monitoring Using Fiber-Optic Sensors (Ingestion)', under grant PDC2021-121172-C22 funded by MICIU/AEI/10.13039/501100011033 and by the European Union Next GenerationEU/PRTR). This work was supported in part by grant PID2022-137269OB-C21 by MICIU/AEI/10.13039/501100011033 and by ERDF 'A way of making Europe'; and grant PID2022-137269OB-C22 by MICIU/AEI/10.13039/501100011033 and by the European Union.
Academica-e. Repositorio Institucional de la Universidad Pública de Navarra
Publicación Contribución de congreso (ConferenceOutput)

Femtosecond laser inscription of diffraction gratings in CYTOP fibers for optical fiber sensing

  • Lomer, Mauro
  • Roldán Varona, Pablo
  • Algorri, J. F.
  • Rodríguez Cobo, Luis
  • Pérez Herrera, Rosa Ana
  • López-Amo Sáinz, Manuel
  • López Higuera, José Miguel
The use of the new CYTOP fibers for the inscription of optical structures and the sensing of different parameters has started to gain importance in the last decade. This work presents the design and manufacture of a CYTOP fiber-based optical structure intended for later use as a refractive index sensor. The structure is based on a diffraction grating inscribed in an area of the fiber with a specific curvature, and previously polished., This work has been supported by the FEDER/Ministerio de Ciencia, Innovación y Universidades and Agencia Estatal de Investigación (RTC-2017-6321-1, PID2019-107270RB-C21 and PID2019-107270RB-C22), the Ministerio de Educación, Cultura y Deporte of Spain (PhD grant FPU2018/02797), and Projects for young researches UPNA 2019.