Pasar al contenido principal

SINTESIS Y OPTIMIZACION DE SISTEMAS DE TRIGENERACION NEUTROS EN CARBONO BASADOS EN ENERGIA SOLAR TERMICA Y BIOMASA CON APOYO DE ALMACENAMIENTO TERMICO

PID2020-115500RB-I00

•
Nombre agencia financiadora Agencia Estatal de Investigación
Acrónimo agencia financiadora AEI
Programa Programa Estatal de I+D+i Orientado a los Retos de la Sociedad
Convocatoria Proyectos de I+D+i (Generación de Conocimiento y Retos Investigación)
Año convocatoria 2020
Plan Estatal 2017-2020 Plan Estatal de Investigación Científica y Técnica y de Innovación
Centro beneficiario UNIVERSIDAD DE ZARAGOZA

Resultados relacionados

Resultados totales (Incluyendo duplicados): 6
Encontrada(s) 1 página(s)

UPCommons. Portal del coneixement obert de la UPC
Publicación Artículo científico (JournalArticle)

Energy communities approach applied to optimize polygeneration systems in residential buildings: case study in Zaragoza, Spain

  • Pinto Maquillon, Edwin Samir|||0000-0003-0231-8795
  • Serra de Renobales, Luis María
  • Lázaro Fernández, Ana
The residential sector plays an important role to combat climate change. It requires alternatives to reduce its energy consumption and greenhouse gases emissions. Thus, polygeneration systems are a suitable alternative enabling efficient use of natural resources with low environmental impact. On the other hand, microgrids are considered a key component for improving power reliability and quality, besides they offer a viable solution for integrating renewable energy sources at a large scale. Accordingly, this paper proposes an approach for the design of polygeneration systems for residential buildings considering them not only as a microgrid but as a smart energy system. A Mixed Integer Linear Programming (MILP) model was developed for the optimization of polygeneration systems considering different constraints which allow the energy system to work as a microgrid. Different thermal and electrical technologies where evaluated under different conditions, finding affordable and sustainable configurations and interesting synergies between technologies. Results show the importance to consider both thermal and electrical demands and technologies simultaneously for the design of energy systems. It is highlighted the displacement of batteries by thermal energy storage to achieve more cost-effective solutions in contrast to the current tendency to uphold battery systems as the key for future energy systems., This work was developed in the frame of the research projects ENE2017-87711-R and PID2020-15500RB-I00, partially funded by the State Research Agency (SRA), the Government of Aragon (Ref: T55- 20R), and the European Regional Development Fund (ERDF). The corresponding author also acknowledges the Margarita Salas grant funded by the Europe Union-NextGenerationEU and the Ministry of Universities of Spain.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Optimal design of trigeneration systems for buildings considering cooperative game theory for allocating production cost to energy services

  • Lozano, Miguel A.
  • Serra, Luis M.
  • Pina, Eduardo A.
In the design of trigeneration plants for buildings, two fundamental issues must be addressed: the synthesis of the plant configuration (installed technologies and capacity, etc.) and the operational planning. Given the variety of technology options available and great diurnal and annual fluctuations in energy demands, finding the optimal supply system of energy services is a complex task. Cost allocation in multi-product systems requires special attention because the way in which allocation is made will affect the prices of the final products and, consequently, the consumers' behaviour. When a polygeneration plant is designed to serve different products, it is possible to achieve a lower total cost. However, if potential consumers are free to participate, the system's management should ensure that every participant shares the benefit of joint production. In trigeneration systems this implies that all consumers should achieve, at least, a lower cost for their demanded energy services than operating separately. The present work proposes a Mixed Integer Linear Programming model to determine the optimal configuration of trigeneration systems that must cover the energy demands of electricity, heating and cooling of a residential complex located in Zaragoza, Spain. The model considers the possibility of using a set of proposed alternative technologies within a superstructure and considers the optimal operation throughout a typical meteorological year. The objective function to be minimized is the total annual cost. The results indicate that compared to consumers standing alone, the optimal trigeneration system can achieve 10.6% cost saving. Ten different cost assessment methods to the three final energy products of the analyzed trigeneration system are rigorously compared. Cooperative game theory shows that all consumers benefit. Using the Shapley values as the distribution criterion, the savings for electricity, heating and cooling consumers are 4.8%, 20.9% and 11.1%, respectively.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Use of a low-cost phase change material emulsion in de-centralized thermal energy storage for district heating network enlargement

  • Rinaldi, Giulia
  • Lázaro, Ana
  • Delgado, Mónica
  • Marín, José María
  • Verda, Vittorio
A detailed heat transfer model of a storage tank was developed to assess the performance of a district heating system with de-centralized storage solutions. The performance of two cases, with water and a low-cost phase change material emulsion as storage medium was analysed for 40 residential buildings in Zaragoza (Spain). The chosen configuration is a typical cylindrical tank with internal coils through which the district heating water flows for the charge and discharge. This decentralized thermal energy storage unit reduced peak demand and mass flow in the network, allowing additional buildings to connect to a saturated grid. Four configurations were examined: (1) A 180 m3 water tank reduced district heating power demand by 36.6 %. (2) The same 180 m3 tank using the emulsion required fewer coils, lowering costs, stabilizing TES temperature, and increasing water supply temperature, thus extending system lifespan. (3) A 130 m³ tank with the emulsion offered operational characteristics similar to the water tank, with economic and structural benefits from reduced size. (4) An 180 m³ optimised tank with the emulsion achieved a 38.8 % reduction in district heating power demand. These configurations demonstrate the efficiency and cost-effectiveness of using phase change material emulsion in thermal energy storage systems.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Rheological study on xylitol crystallization for its use as phase change material: analytical and statistical analysis

  • Navarro, Miguel
  • Gracia, Zeus
  • Asín, Jesús
  • Lázaro, Ana
  • Martí, Marta
  • Delgado, Mónica
In a global context in which decarbonization of society is wanted through the use of renewable sources, energy storage plays a fundamental role. Among the different forms of energy storage that exists, this work focuses on latent heat energy storage (LHTES) for medium-low temperatures, between 70 °C and 120 °C. Xylitol, a sugar-alcohol, is a promising phase change material (PCM) due to its low cost, low corrosivity, high latent heat (240 J/g) and a melting temperature of 92 °C. However, its use as PCM is hindered by a high degree of supercooling and a low crystallization rate. To address these challenges, this work used a seeding and shearing technique to trigger crystallization. Rheological experiments were performed to monitor viscosity changes during crystallization, in order to study the crystallization induction time. The systematic analysis included the effects of temperature (70–90 °C), shear rate(1-100s−1), and seed crystal size (300–400 μm and 600–700 μm). Key results show that temperature is the most dominant factor. The shortest induction time at 70 °C was found at 10s, increasing to 1500s at 90 °C. Increasing seed size and reducing the rheometer gap also shortened induction times, while shear rate had minimal influence, likely due to non-uniform shear during the test. For practical applications, operating at 80 °C is recommended to balance induction time and energy loss due to supercooling. Optimizing shear-triggered mechanism, such as stirred tanks designs, can improve crystallization controllability.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Optimal operation and marginal costs in a complex polygeneration system including thermal energy storage and DHCN pipelines

  • De Souza, Ronelly José
  • Serra, Luis M.
  • Lozano, Miguel A.
  • Reini, Mauro
This paper proposes a thermoeconomic analysis to determine the hourly marginal costs of the optimal operation of a complex polygeneration system when the energy demand for a specific energy service increases at any time step, without modifying the operation mode of the system. The work analyses a case study which considers a mixed integer linear programming (MILP) model of an energy community (EC), comprising nine tertiary sector buildings and a central unit supplied by natural gas, solar energy, and electricity. The buildings exchange electricity through a local electric grid as well as heating and cooling through a district heating and cooling network (DHCN). The paper focuses on the marginal cost (MC) analysis of the electricity and heating demands regarding two of the EC buildings by evaluating representative time steps of a typical winter day. Additionally, a detailed analysis of the cost formation process for polygeneration heat production is conducted, clarifying the influence of thermal energy storage (TES) and DHCN on the marginal cost of heat production. The proposed marginal cost analysis reveals strategies for managing increased heat or electricity demands with minimal impact on the objective function. While the applied methodology offers robustness and transparency, it should be noted that the model under analysis does not include dynamic inefficiencies such as start-up/shut-down of technologies, and renewable variability is represented through deterministic time series. Thus, the mentioned optimal operation refers to the most cost-effective response to marginal demand changes within fixed operational modes. Obtained results indicate that optimal marginal paths have the potential to reduce operation costs by 26% compared to non-optimal ones.
Recercat. Dipósit de la Recerca de Catalunya
Publicación Artículo científico (JournalArticle)

Energy communities approach applied to optimize polygeneration systems in residential buildings: case study in Zaragoza, Spain

  • Pinto Maquillon, Edwin Samir
  • Serra de Renobales, Luis María
  • Lázaro Fernández, Ana
The residential sector plays an important role to combat climate change. It requires alternatives to reduce its energy consumption and greenhouse gases emissions. Thus, polygeneration systems are a suitable alternative enabling efficient use of natural resources with low environmental impact. On the other hand, microgrids are considered a key component for improving power reliability and quality, besides they offer a viable solution for integrating renewable energy sources at a large scale. Accordingly, this paper proposes an approach for the design of polygeneration systems for residential buildings considering them not only as a microgrid but as a smart energy system. A Mixed Integer Linear Programming (MILP) model was developed for the optimization of polygeneration systems considering different constraints which allow the energy system to work as a microgrid. Different thermal and electrical technologies where evaluated under different conditions, finding affordable and sustainable configurations and interesting synergies between technologies. Results show the importance to consider both thermal and electrical demands and technologies simultaneously for the design of energy systems. It is highlighted the displacement of batteries by thermal energy storage to achieve more cost-effective solutions in contrast to the current tendency to uphold battery systems as the key for future energy systems., This work was developed in the frame of the research projects ENE2017-87711-R and PID2020-15500RB-I00, partially funded by the State Research Agency (SRA), the Government of Aragon (Ref: T55- 20R), and the European Regional Development Fund (ERDF). The corresponding author also acknowledges the Margarita Salas grant funded by the Europe Union-NextGenerationEU and the Ministry of Universities of Spain., Postprint (author's final draft)