Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 7
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Raman spectroscopy insights into the α- and δ-phases of formamidinium lead iodide (FAPbI3)

  • Driscoll, Elizabeth
  • Orera, Alodia
  • Anderson, P. A.
  • Sanjuán, M. L.
  • Slater, Peter
Solar perovskites have received phenomenal attention and success over the past decade, due to their high power conversion efficiencies (PCE), ease of fabrication and low cost which has enabled the prospect of them being a real commercial contender to the traditional silicon technology. In one of the several developments on the archetypal MAPbI3 perovskite absorber layer, FAPbI3 was found to obtain a higher PCE, likely due to its more optimum band gap, with doping strategies focusing on the inclusion of MA+/Cs+ cations to avoid the unfavourable phase transformation to a photoinactive phase. To better understand the phase change from the photoactive cubic (Pm[3 with combining macron]m) black (α) phase to the unwanted photoinactive (P63/mmc) yellow (δ) phase, we make use of variable temperature Raman spectroscopy to probe the molecular species and its relationship to the inorganic framework. We show for the first time there to be no Raman active modes for the α phase up to 4000 cm−1, which can be correlated to the Pm[3 with combining macron]m cubic symmetry of that phase. Our detailed studies suggest that previous reports of the observation of Raman peaks for this phase are likely associated with degradation reactions from the localised laser exposure and the formation of Raman active lead oxide. In addition, we have identified water as a contributing factor to the transformation, and observed a corresponding signal in the Raman spectra, although confirmation of its exact role still remains inconclusive., The University of Birmingham PhD scholarship (EHD). AO acknowledges financial support from the Ramón y Cajal program (RYC2018-025553-I)., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Advanced metal oxide infiltrated electrodes for boosting the performance of solid oxide cells

  • Orera, Alodia
  • Betato, Alejandro
  • Silva-Treviño, Jorge
  • Larrea, Ángel
  • Laguna-Bercero, M. A.
An efficient way for boosting the performance of solid oxide electrodes is the infiltration of metallic nanoparticles into both electrodes. In this work we will focus on improving the performance of standard lanthanum strontium manganite oxygen electrodes, by the addition of different metal oxide nanoparticles. First studies will be performed using cerium oxide nanoparticles, as this is the classic oxide already proposed in the literature. Other novel metal oxides such as praseodymium or manganese oxide will be explored, as studies in the literature for these two metal oxides are very scarce. The effect of metal oxide infiltration into LSM/YSZ oxygen electrodes will be studied in both symmetrical cells and complete microtubular cells using conventional fuel electrodes (NiO-YSZ) and electrolytes (YSZ). The obtained current densities in both fuel cell and electrolysis modes are significantly enhanced in comparison with other results in the literature for microtubular configuration., This research has received funding from grants PID2019-107106RB-C32 funded by MCIN/AEI/10.13039/501100011033 and RTI2018-098944-J-I00 funded by MCIN/AEI/10.13039/501100011033 and by “ERDF A way of making Europe”. A. O. also acknowledges financial support from the Ramón y Cajal program (RYC2018-025553-I) funded by MCIN/AEI/10.13039/501100011033 and by “ESF Investing in your future”. Furthermore, the use of Servicio General de Apoyo a la Investigación (SAI, University of Zaragoza) is also acknowledged., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Eutectic ceramics of the CeO2 – ZrO2 – MgO system produced by laser-assisted directional solidification

  • Orera, Alodia
  • Oliete, Patricia B.
  • Merino, R. I.
  • Sanjuán, M. L.
Oxide eutectics have great potentiality as structural or functional materials, owing to the outstanding properties derived from the eutectic microstructure. Among them, the eutectic of the ZrO2 – MgO system is particularly noteworthy because of the unusual combination of thermomechanical, optical and electrical properties. In a recent application, Zr1-δMgδO2-δ – MgO eutectic oxides have been used to produce porous supports for molten-carbonate based CO2 separation membranes. Here we explore composite ceramic oxides of the CexZr1-xO2 – MgO (x ​≤ ​0.5) system with eutectic microstructure, with the motivation that incorporating cerium may enhance the CO2 permeation properties. Eutectic composites with different cerium content are produced by a laser-assisted directional solidification technique at variable solidification rate, v. In all cases the composite bicrystal consists of two phases, MgO and a fluorite-like (CexZr1-x)1-yMgyO2-y phase. A purely fibrilar microstructure is found for x ​≥ ​0.3 ​at v ​= ​25 ​mm/h, with MgO fibres embedded within the fluorite-like matrix. The MgO mol% in the eutectic composites decreases from ∼53% for x ​= ​0 to ∼48% for x ​= ​0.5. X-ray and Raman results evidence long-range ordering in a quasi-tetragonal monoclinic symmetry for x ​= ​0.5. Impedance spectroscopy results are consistent with a change from ionic to mainly electronic conductivity when the atmosphere is changed from air or Ar to 5%H2–Ar., The authors acknowledge financial support from the Spanish Ministerio de Ciencia e Innovación and Feder Funds from the European Comission under projects PID2019-107106RB-C32 and PID2021-124863OB-I00 funded by MCIN/AEI/10.13039/501100011033. The Departamento de Ciencia, Universidad y Sociedad del Conocimiento is acknowledged for the financial support to the research group T02_20R. A. O. also acknowledges financial support from the Ramón y Cajal program (RYC2018-025553-I) funded by MCIN/AEI/10.13039/501100011033., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Probing high oxygen activity in YSZ electrolyte

  • Robles-Fernandez, Adrian
  • Orera, Alodia
  • Peña, J. I.
  • Merino, R. I.
The redox behavior of terbium and praseodymium doped yttria-stabilized zirconia (YSZ) is studied. The aim is to identify spectroscopic probes and a suitable experimental procedure to monitor the oxygen activity in YSZ electrolytes in solid oxide cells with spatial resolution and at operation conditions (e.g. at high temperatures). Sintered ceramics and crystals with 0.3 to 10 at% content of Pr or Tb ions in YSZ were prepared. Upon equilibration in atmospheres from 10−20 to 100 bar PO2around 800 °C, the majority of these rare earth ions are in the 3 + oxidation state. At oxygen pressures above 0.001 bar, the small proportion of Tb4+ and Pr4+ formed give rise to intense optical absorption around 300–500 nm and to decreased reflectance. From the reflectance measurements it is shown that the Tb4+ concentration increases as PO21/4, as correspond to the trapping of the holes generated upon the oxygen incorporation as Tb4+. This competitive absorption causes a decrease of the Tb3+ luminescence. A quantitative relationship of the Tb3+ luminescence intensity with PO2 at 800 °C has been found, which is compatible with the trapping model. The spatial resolution of the experimental procedure could be very roughly estimated of the order of 100 μm., This work was financially supported by grant RTI2018-098944-J-I00 funded by MCIN/AEI/ 10.13039/501100011033 and by "ERDF A way of making Europe" and Grant RYC2018–025553-I funded by MCIN/AEI/ 10.13039/501100011033 and by "ESF Investing in your future." The Departamento de Ciencia, Universidad y Sociedad del Conocimiento del Gobierno de Aragón is also acknowledged for the financial support to the Research Group T02 20 R. Adrián Robles-Fernández thanks for the grant BES-2016–078508 funded by MCIN/AEI/ 10.13039/501100011033 and by "ESF Investing in your future.", Peer reviewed
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Raman spectroscopy insights into the a- and d-phases of formamidinium lead iodide (FAPbI3)

  • Driscoll, E.H.
  • Orera, A.
  • Anderson, P.A.
  • Sanjuán, M.L.
  • Slater, P.R.
Solar perovskites have received phenomenal attention and success over the past decade, due to their high power conversion efficiencies (PCE), ease of fabrication and low cost which has enabled the prospect of them being a real commercial contender to the traditional silicon technology. In one of the several developments on the archetypal MAPbI3perovskite absorber layer, FAPbI3was found to obtain a higher PCE, likely due to its more optimum band gap, with doping strategies focusing on the inclusion of MA+/Cs+cations to avoid the unfavourable phase transformation to a photoinactive phase. To better understand the phase change from the photoactive cubic (Pm3¯m) black (a) phase to the unwanted photoinactive (P63/mmc) yellow (d) phase, we make use of variable temperature Raman spectroscopy to probe the molecular species and its relationship to the inorganic framework. We show for the first time there to be no Raman active modes for the a phase up to 4000 cm-1, which can be correlated to thePm3¯mcubic symmetry of that phase. Our detailed studies suggest that previous reports of the observation of Raman peaks for this phase are likely associated with degradation reactions from the localised laser exposure and the formation of Raman active lead oxide. In addition, we have identified water as a contributing factor to the transformation, and observed a corresponding signal in the Raman spectra, although confirmation of its exact role still remains inconclusive.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Probing high oxygen activity in YSZ electrolyte

  • Robles-Fernández, A.
  • Orera, A.
  • Peña, J. I.
  • Merino, R. I.
The redox behavior of terbium and praseodymium doped yttria-stabilized zirconia (YSZ) is studied. The aim is to identify spectroscopic probes and a suitable experimental procedure to monitor the oxygen activity in YSZ electrolytes in solid oxide cells with spatial resolution and at operation conditions (e.g. at high temperatures). Sintered ceramics and crystals with 0.3 to 10 at% content of Pr or Tb ions in YSZ were prepared. Upon equilibration in atmospheres from 10-20to 100 bar PO2around 800 °C, the majority of these rare earth ions are in the 3 + oxidation state. At oxygen pressures above 0.001 bar, the small proportion of Tb4+and Pr4+formed give rise to intense optical absorption around 300 500 nm and to decreased reflectance. From the reflectance measurements it is shown that the Tb4+concentration increases as PO21/4, as correspond to the trapping of the holes generated upon the oxygen incorporation as Tb4+. This competitive absorption causes a decrease of the Tb3+luminescence. A quantitative relationship of the Tb3+luminescence intensity with PO2at 800 °C has been found, which is compatible with the trapping model. The spatial resolution of the experimental procedure could be very roughly estimated of the order of 100 µm.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Advanced metal oxide infiltrated electrodes for boosting the performance of solid oxide cells

  • Orera, A.
  • Betato, A.
  • Silva-Trevino, J.
  • Larrea, Á.
  • Laguna-Bercero, M. Á.
An efficient way for boosting the performance of solid oxide electrodes is the infiltration of metallic nanoparticles into both electrodes. In this work we will focus on improving the performance of standard lanthanum strontium manganite oxygen electrodes, by the addition of different metal oxide nanoparticles. First studies will be performed using cerium oxide nanoparticles, as this is the classic oxide already proposed in the literature. Other novel metal oxides such as praseodymium or manganese oxide will be explored, as studies in the literature for these two metal oxides are very scarce. The effect of metal oxide infiltration into LSM/YSZ oxygen electrodes will be studied in both symmetrical cells and complete microtubular cells using conventional fuel electrodes (NiO-YSZ) and electrolytes (YSZ). The obtained current densities in both fuel cell and electrolysis modes are significantly enhanced in comparison with other results in the literature for microtubular configuration.