Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 5
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Tuning the antioxidant and antibacterial properties of lignin by physicochemical modification during sequential acid precipitation from Kraft black liquor

  • Eugenio, María E.
  • García-Fuentevilla, Luisa
  • Martín-Sampedro, Raquel
  • Santos, José I.
  • Wicklein, Bernd
  • Ibarra, David
23 Pág., Turning lignin from black liquor waste into value-added bioactive agents is one of the possible routes for improving the sustainability and profitability of lignocellulosic industry. However, due to chemical and structural variability of lignin, it is necessary to isolate specific lignin fractions from black liquor with the purpose to achieve samples with unique chemical and structural characteristics and therefore, specific biological activities. In this study, poplar lignin fractions isolated from Kraft black liquor by sequential acid precipitation at pH´s 7.5, 5 and 2.5 (denoted as P-7.5, P-5 and P-2.5) were characterized according to their physicochemical, antioxidant and antibacterial properties. In general, lignin fractions displayed a wide elimination of lateral chains (aryl-β ether and C–C) and, therefore a high phenolic content and low molecular weight, as the pH sequential precipitation was decreased from 7.5 to 2.5. Moreover, thermal analysis revealed that the P-7.5 lignin fraction showed higher thermal stability than P-2.5 and P-5. In terms of antioxidant activity, the P-7.5 lignin fraction, with a higher S/G ratio and a less oxidized structure compared to P-5 and P-2.5, exhibited higher antioxidant activity. In addition, lower antibacterial effect was observed for all lignin fractions against Escherichia coli compared to that obtained against Staphylococcus aureus. Among them, the P-2.5 and P-5 fractions, with higher phenolic content and lower molecular weight values than P-7.5, showed a greater antibacterial effect against S. aureus., Open Access funding provided thanks to the CRUE-CSIC agreement with Springer Nature. The authors wish to thank the project TED 2021-132122B-C1 funded by MCIN/AEI/10.13039/501100011033 and by the “European UnionNextGenerationEU/PRTR” and the project PID2022-141965OB-C21 funded by MCIN/AEI/10.13039/501100011033 and by “ERDF A way of making Europe” to support this study. BW acknowledges the grant PID2019-107022RJ-I00 funded by MCIN/AEI/10.13039/501100011033., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Bioactive nanocellulose films by incorporation of enzymatically polymerized lignin nanoparticles

  • García-Fuentevilla, Luisa
  • Martín-Sampedro, Raquel
  • Darder, Margarita
  • Ibarra, David
  • Eugenio, María E.
In the search of new bioactive and biobased films, the use of lignin nanoparticles (LNP) and cellulose nanofibers (CNF) has gained potential relevance in the last years. In this context, an enzymatic and environmentally friendly pretreatment with laccases has been proposed in this work to modify the properties of the developed cellulose-lignin nanocomposite films. Thus, the laccase treatment successfully polymerized kraft lignin as indicated by the increase in weight average molecular weight (from 3621 to 5681 Da) and the reduction in phenolic content (from 552 to 324 mg GAE/g lignin). Moreover, this polymerization also caused a significant reduction in the size of the resulting LNP (6.8 ± 2.4 nm) compared to those obtained from untreated lignin (62 ± 22 nm). The incorporation of both untreated and treated LNP conferred antioxidant, antibacterial and UV-shielding capabilities to the final LNP-CNF films, observing higher antioxidant and UV-shielding values with polymerized LNP probably due to its tiny size and conjugated functional groups, respectively. Furthermore, films with 5 % LNP also showed better thermal stability, elongation at break, water vapor permeability and transparency, compared to CNF control films., This work was supported by the MCIN/AEI/10.13039/501100011033 and “ERDF A way of making Europe”, [project PID2022-141965OB-C21 and PID2022-137889OB-I00]; MCIN/AEI/10.13039/501100011033 and the “European Union Next Generation EU/PRTR” [project TED 2021-132122B-C1]., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Applicability of a laccase from the eucalypt wood endophytic fungus Hormonema sp. CECT-13092 for advanced bioethanol production

  • García-Fuentevilla, Luisa
  • Eugenio, María E.
  • Martín-Sampedro, Raquel
  • Ibarra, David
This work studies, for the first time, the potential of a laccase from the endophyte fungus Hormonema sp. CECT-13092, compared to a laccase from the saprophyte fungus Trametes villosa, for delignification and detoxification of steam-exploded eucalypt to improve subsequent bioethanol production. Regarding laccase delignification, the use of Hormonema sp. and T. villosa laccases did not show evidence of delignification of steam-exploded material, and rather low glucose and xylose recoveries were obtained during saccharification assays of laccase-treated samples compared with their respective controls. With regard to laccase detoxification, the reduction of the total phenolic inhibitors content presents in steam-exploded material by both laccases (phenols removal of 47 % and 60 % by Hormonema sp. and T. villosa laccases, respectively), triggered the fermentation by Saccharomyces cerevisiae of laccase-treated samples when 0.2 g L-1 of inoculum was used during a simultaneous saccharification and fermentation (SSF) process. Moreover, when the inoculum was increased from 0.2 to 1.0 g L-1, both laccases shortened the yeast lag phase during the SSF process. Then, faster glucose consumption and ethanol production rates (ethanol productivity values of 0.25 and 0.28 g L-1 h-1 for T. villosa and Hormonema sp. laccases, respectively, compared to 0.02 g L-1 h-1 for control samples) were noticed. This fact proves the high potential of this new entophytic fungal laccase for bioethanol production enhancement, comparable to commercial laccases., The authors wish to thank the projects PID2022–141965OB-C21 funded by MCIN/AEI/10.13039/501100011033 and by “ERDF A way of making Europe”, and TED 2021-132122B-C1, funded by MCIN/AEI/10.13039/501100011033 and by the “European UnionNextGenerationEU/PRTR”, to support this study. The project TEC-2024/BIO-27 (AgroSUSTEC-CM), funded by Comunidad de Madrid, is also grateful., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

A sustainable valorization approach of Kraft black liquor from Robinia pseudoacacia L.: lignin precipitation followed by green solvents extraction of phenols from delignified liquor

  • Sánchez-Monedero, A.
  • Cañadas, Raquel
  • Martín-Sampedro, Raquel
  • Santos, José Ignacio
  • Eugenio, María E.
  • Ibarra, David
13 páginas.- 6 figuras.- 2 tablas..- referencias.- Supplementary data to this article can be found online at https://doi.org/10.1016/j.jenvman.2025.126515, Kraft black liquor is considered a renewable feedstock for value-added compounds such as lignin and phenols, which should be valorized rather than incinerated for energy production. Herein, Robinia pseudoacacia L. was subjected to Kraft pulping and the resulting black liquor was recovered for lignin and phenols extraction. The liquor was acidified to isolate lignin and the residual aqueous phase from lignin precipitation was subjected to liquid-liquid extraction. For latter, two bio-based solvents (2-methyltetrahydrofuran (2-MeTHF) and cyclopentyl methyl ether (CPME)) and ethyl acetate (EA) as a conventional organic solvent were used. The chemical composition of lignin was evaluated by standard method, whereas its structural characteristics were analyzed by Nuclear Magnetic Resonance (NMR) and Fourier-Transform Infrared (FTIR) spectroscopy, and Size Exclusion Chromatography (SEC). The phenols extraction efficiency of solvents was determined by UV-Vis spectrometry, using Folin-Ciocalteu assay, and subsequently, phenols were tentatively identified and quantified by HPLC-DAD chromatography. The antioxidant activity of lignin and phenolic extracts were characterized by DPPH scavenging tests. Recovered lignin (85 %) displayed a significant degradation of lateral chains and, therefore, a high phenolic content and low molecular weight. Based on these characteristics, a lignin with antioxidant activity was recovered. Concerning phenols extraction from delignified liquor, 2-MeTHF displayed the highest extraction capacity (78 %), followed by EA (52 %) and CPME (33 %). The organic extracts showed antioxidant activity, following a comparable tendency to that of the total phenolic content values (2-MeTHF > EA > CPME). Among the different phenols identified, highlights the flavonoids dihydrorobinetin and robinetin, with potential to be employed in different sectors., The authors wish to thank the project TED 2021-132122B-C1 funded by MCIN/AEI/10.13039/501100011033 and by the "European Union-NextGenerationEU/PRTR" and the project PID2022-141965OB-C21 funded by MCIN/AEI/10.13039/501100011033 and by "ERDF A way of making Europe" to support this study. AgroSUSTEC-CM (TEC-2024/BIO-27) project, funded by Comunidad de Madrid, is also grateful. Authors are also grateful for the support of the Interdisciplinary Platform for Sustainable Plastics towards a Circular Economy (SusPlast-CSIC), Madrid, Spain; Interdisciplinary Platform for Sustainability and Circular Economy (SosEcoCir-CSIC), Madrid, Spain; Interdisciplinary Platform Horizonte Verde (CSIC), Madrid, Spain; and RED LIGNOCEL (RED2024-153800-T) funded by MICIU/AEI/10.13039/501100011033., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Modulated Optoelectronic Properties of MOF/CNF Bionanocomposite Films for Bacterial Growth Control under Visible Light

  • Guerrero, Joab D.
  • Martín-Sampedro, Raquel
  • Cuadrado, Ramón
  • Llano, Iván
  • García-Frutos, Eva M.
  • Aranda, Pilar
  • Ibarra, David
  • Eugenio, María E.
  • Vázquez, Luis
  • Pérez-Carvajal, Javier
  • Darder, Margarita
The present work reports an experimental and theoretical investigation of tuning the optoelectronic properties of MIL-125-NH2 nanoparticles by grafting aromatic molecules. The postsynthetic modification of the MOF MIL-125-NH2 with 3,4-dihydroxybenzaldehyde (DBA) resulted in a 23% reduction in the bandgap energy, from 2.71 to 2.08 eV, while increasing the absorbance throughout the visible region of the spectrum, which could be attributed to stabilization due to enol-imine/keto-enamine tautomerism, as supported by DFT theoretical calculations. Pristine and grafted MOFs were assembled into cellulose nanofibers (CNF) for the preparation of functional CNF-based bionanocomposites. The mechanical properties of the films improved, with Young’s modulus increasing from 1.3 GPa in CNF to 7.5 GPa in the film with 20% MOF loading. The potential of the developed materials for photocatalytic antimicrobial therapy was evaluated against Staphylococcus aureus (S. aureus). In vitro tests showed that both bionanocomposite films with pristine and DBA-modified MOF remarkably reduced bacterial growth due to the photocatalytic action of the MOF under visible light. The inhibition values were around 58% and 72%, respectively, while minimal inhibition was observed under dark conditions. These initial results support the potential use of the developed bionanocomposite films as wound dressings., The authors acknowledge financial support from projects funded by AEI, MCIN/AEI/10.13039/501100011033 (Spain, projects PID2019-105479RB-I00, PID2022-137889OB-I00, and PID2022-141965OB-C21) and “ERDF A way of making Europe” (EU, projects PID2022-137889OB-I00 and PID2022-141965OB-C21), and projects TED2021-131223B–I00 and TED2021-132122B–C1 funded by MCIN/AEI/10.13039/501100011033 and by the “European Union NextGeneration EU/PRTR”. J.P.-C. also acknowledges financial support from RYC2022-037460-I Ramon y Cajal contract, funded by AEI (MCIN/AEI/10.13039/501100011033). R.C. and J.P.-C. thankfully acknowledge RES resources provided by the Barcelona Supercomputing Center (BSC) in MareNostrum5 GPP to QHS-2024-2-0024. J.D.G. acknowledges the PhD fellowship CSIC PRE23_ICMM_111 (AEI, Spain). We also thank the Interdisciplinary Platforms for Sustainable Plastics towards a Circular Economy (SusPlast) and for Sustainability and Circular Economy (SosEcoCir) of the Spanish National Research Council (CSIC). The authors also acknowledge Dr A. Jacas for the design and construction of the irradiation device., Peer reviewed