Pasar al contenido principal

COMBUSTION A BAJA TEMPERATURA EN MOTORES DIESEL PARA REDUCIR SIMULTANEAMENTE LAS EMISIONES DE NOX Y HUMOS

TRA2010-20271

•
Nombre agencia financiadora Ministerio de Ciencia e Innovación
Acrónimo agencia financiadora MICINN
Programa Programa Nacional de Proyectos de Investigación Fundamental
Subprograma Subprograma de Proyectos de Investigación Fundamental no Orientada
Convocatoria Proyectos I+D
Año convocatoria 2010
Plan Estatal 2008-2011 Plan Nacional de Investigación Científica, Desarrollo e Innovación Tecnológica
Unidad de gestión Subdirección General de Proyectos de Investigación
Centro beneficiario UNIVERSITAT POLITÈCNICA DE VALÈNCIA
Identificador persistente http://dx.doi.org/10.13039/501100004837

Resultados relacionados

Resultados totales (Incluyendo duplicados): 3
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Evaluation of massive exhaust gas recirculation and Miller cycle strategies for mixing-controlled low temperature combustion in a heavy duty diesel engine

  • Benajes, Jesús|||0000-0002-1653-9188
  • Molina, Santiago|||0000-0001-7879-2421
  • Novella Rosa, Ricardo|||0000-0002-5123-6924
  • Belarte Mañes, Eduardo
The future of compression ignition engines depends on their ability for keeping their competitiveness in terms of fuel consumption compared to spark-ignition engines. In this competitive framework, the Low Temperature Combustion (LTC) concept is a promising alternative to decrease NOx and soot emissions. Thus, this research focuses on implementing the LTC concept, but keeping the conventional mixing-controlled combustion process to overcome the well-known drawbacks of the highly-premixed combustion concepts, including load limitations and lack of combustion control. Two strategies for implementing the mixing-controlled LTC concept were evaluated. The first strategy relies on decreasing the intake oxygen concentration introducing high rates of cooled EGR. The second strategy consists of decreasing the compression temperature by advancing the intake valves closing angle to reduce the effective compression ratio, compensating the air mass losses by increasing boost pressure (Miller cycle). These strategies were tested in a single-cylinder heavy-duty research engine. Additionally, 3D-CFD modeling was used to give insight into local in-cylinder conditions during the injection-combustion process. Results confirm the suitability of both strategies for reducing NOx and soot emissions, while their main drawback is the increment in fuel consumption. However, they present intrinsic differences in terms of local equivalence ratios and temperatures along combustion., The authors of this paper thank the Spanish Ministry of Economic and Competitively for the financial support of this research through the project TRA2010-20271 (LOWTECOM).
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Comprehensive modeling study analyzing the insights of the NO NO2 conversion process in current diesel engines

  • Benajes, Jesús|||0000-0002-1653-9188
  • López, J. Javier|||0000-0002-9486-2511
  • Novella Rosa, Ricardo|||0000-0002-5123-6924
  • Redón Lurbe, Pau
Multiple researches have focused on reducing the NOx emissions and the greatest results have been achieved when lowering the combustion temperature by employing massive exhaust gas recirculation rates (LTC). Despite this benefit, a substantial increase in the NO2 contribution to the NOx emissions has also been observed, which is the most harmful specie and is important for the design and positioning of the after-treatment devices. To understand how NO2 behaves and how it contributes to the total NOx (NO2/NOx), not only under LTC but also for CDC conditions, a stepwise computational research study was performed with Chemkin Pro software, due to the complexity of isolating the different phenomena studied, to analyze: (1) general equilibrium conditions and (2) the influence of typical diesel engine phenomena (combustion and cooling effects) under non-equilibrium conditions. The results obtained under equilibrium state confirm the theoretical guidelines established for the NO2 formation process. When considering a combustion process (HCCI-like mode), the previous results were corroborated as well as the fact that only poor or slow combustion processes are responsible for the NO2 formation. Additionally, it reflected a cyclic process between NO and NO2, or in other words, it is suffice to just concentrate on NO to be able to predict NO2. Finally, the results yield after analyzing some cooling effects, inherent to how diesel engines work (the expansion stroke, dilution of combustion products with the rest of in-cylinder charge and the one caused by wall impingement), reflect that: (1) the dilution effect explains the 10% of the NO2/NOx ratio under CDC conditions and (2) the coupling of the dilution with the expansion stroke cooling effects can explain the NO2 increase typical of LTC conditions. These results were also supported by some experiments performed in a single-cylinder diesel engine. Consequently, the cooling effect caused by dilution should be considered when modeling the NO2 formation just like the expansion stroke., The authors would like to acknowledge the contribution of the Spanish Ministry of Economic and Competitively for the financial support of the present research study associate to the Projects TRA 2008-06448 (VELOSOOT) and TRA 2010-20271 (LOWTECOM). Additionally, special acknowledgement to Dr. L. Pickett which kindly shared a copy of the TSL model to perform the diesel spray simulations.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Implementation of the Partially Premixed Combustion concept in a 2-stroke HSDI diesel engine fueled with gasoline

  • Benajes, Jesús|||0000-0002-1653-9188
  • Molina, Santiago|||0000-0001-7879-2421
  • Novella Rosa, Ricardo|||0000-0002-5123-6924
  • De Lima Moradell, Daniela Andreina
Partially Premixed Combustion (PPC) of fuels in the gasoline octane range has proven to combine low NOX and soot emissions with high indicated efficiencies, while still retaining control over combustion phasing with the injection event. Previous research performed in four-stroke engines, has shown how the operating region where gasoline PPC concept can be successfully implemented is largely linked to the octane number of the fuel, making difficult to cover the entire load range with a fixed fuel. In this framework, 2-stroke engines arise as a promising solution to extend the load range of gasoline PPC concept, since it intrinsically provides equivalent torque response with only half the IMEP required in a 4-stroke cycle. Moreover, 2-stroke architecture provides high flexibility on the air management parameters to substantially control the cylinder conditions and affect the combustion environment, allowing proper combustion control even in low load conditions. An experimental investigation has been performed to evaluate the potential of the PPC concept for pollutant control, using a commercial gasoline with Research Octane Number of 95 in a newly-designed 2-stroke poppet valves automotive diesel engine. The experimental results confirm how it is possible to achieve stable gasoline PPC combustion at a low speed medium load point (1200 rpm, 5 bar IMEP); with good combustion stability (σIMEP below 3%), high combustion efficiency (over 98%), and low NOX and zero soot levels; thanks to the wide control of the cylinder gas temperature provided by the air management settings. Nevertheless, in agreement to the results reported in the literature, the indicated cycle efficiency attained at this low load operating condition is lower than the obtained in conventional diesel combustion conditions. Therefore, a dedicated optimization process of the engine hardware and engine settings is required to fully exploit the benefits of gasoline PPC concept in the investigated 2-stroke engine architecture., The authors of this paper thank the Spanish Ministry of Economy and Competitiveness for the financial support of this research through the Project TRA 2010-20271 (LOWTECOM).