Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 2
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Impact of Feedstock Nature on Thermal Conductivity of YSZ Thermal Barrier Coatings Obtained by Plasma Spraying

  • Carpio-Cobo, Pablo
  • Miranda, M.
  • Sánchez, E.
  • Salvador Moya, Mª Dolores|||0000-0002-4242-478X
  • Benavente Martínez, Rut|||0000-0002-4566-9475
  • Borrell Tomás, María Amparo|||0000-0003-4292-4538
[EN] Yttria-stabilized zirconia (YSZ) coatings with low thermal conductivity were obtained using three different particle size distributions as starting powder: nano-, submicron- and bimodal submicron/nano-sized particles. On the one hand, these particles were reconstituted into micrometric, spray-dry agglomerates, which were subsequently deposited by means of conventional atmospheric plasma spraying (APS). On the other hand, the starting particles were dispersed in water and the resultant suspensions were deposited by means of suspension plasma spraying (SPS). The coatings were thermally treated to assess their sintering resistance. As-sprayed and thermally treated coatings were then characterized in terms of microstructure (FEG-SEM) and thermal diffusivity (laser flash equipment). The results showed that SPS coatings exhibited extremely low thermal conductivity at low temperature which drastically augmented with increasing temperature. On the other hand, APS coatings also exhibited low thermal conductivities but their values were higher than those of the SPS coatings at the lowest temperature tested while the conductivities hardly varied with temperature., This work has been supported by the Spanish Ministry of Economy and Competitiveness (project MAT2015-67586-C3-R) and Research Promotion Plan of the Universitat Jaume I, action 2.1 (ref. E-2011 - 05) and action 3.1 (ref. PREDOC/2009/10). A. Borrell acknowledges the Spanish Ministry of Economy and Competitiveness for her Juan de la Cierva-Incorporacion contract (IJCI-2014-19839). M. Miranda would like to thank the European Commission (FP7-Marie Curie Intra-European Fellowship, BIOHYMAT).
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Correlation of thermal conductivity of suspension plasma sprayed yttria stabilized zirconia coatings with some microstructural effects

  • Carpio, Pablo
  • Blochet, Quentin
  • Pateyron, Bernard
  • Pawlowski, Lech
  • Sanchez, Enrique
  • Salvador Moya, Mª Dolores|||0000-0002-4242-478X
  • Borrell Tomás, María Amparo|||0000-0003-4292-4538
Yttria-stabilized zirconia (3YSZ) coatings were successfully obtained by suspension plasma spraying. The coatings present generally two-zones-microstructure comprising nanostructured zones contributed by unmolten, partially sintered nanoparticles sintered surrounded by lamellar splats formed from molten and agglomerated in-flight fine solids. In addition, different types of cracks inside the coating microstructure were classified and quantified by image analysis such as e.g. inner microcracks and segmentation cracks associated with quenching process as well as horizontal interlamellar cracks. Thermophysical properties of sprayed coatings were tested with a thermal diffusivity set up basing onto light flash principle. Subsequently, the thermal conductivity was determined with the use of literature data of density and specific heat. The calculations showed very low thermal conductivities values. The values did not correlate with coatings porosity data. Consequently, the analysis of variance (ANOVA) test allowed evaluating the possible impact of the various types of cracks on thermal conductivity. By this analysis, a good correlation between vertical cracks, which include microcracks and segmentation cracks, and thermal conductivity was found. The findings also confirmed the increase of thermal conductivity associated with this type of cracks., This work has been supported by the Spanish Ministry of Science and Innovation (project MAT2009-14144-C03) and the Research Promotion Plan of the Universitat Jaume I, action 2.1 (ref. E-2011-05) and action 3.1 (ref. PREDOC/2009/10).