Skip to main content

NUEVOS COMPONENTES Y DISPOSITIVOS PARA VALIDACION E INTEGRACION DE PEMFCS EN UN SISTEMA DE ENERGIA NO CONTAMINANTE

ENE2013-49111-C2-1-R

•
Funding agency name Ministerio de Economía y Competitividad
Funding agency acronym MINECO
Program Programa Estatal de I+D+i Orientado a los Retos de la Sociedad
Call Proyectos I+D+i Retos de Investigación
Call year 2013
State Plan 2013-2016 Plan Estatal de Investigación Científica y Técnica y de Innovación
Management unit Secretaría de Estado de Educación, Formación Profesional y Universidades
Beneficiary centre AGENCIA ESTATAL CONSEJO SUPERIOR DE INVESTIGACIONES CIENTIFICAS (CSIC)

Resultados relacionados

Resultados totales (Incluyendo duplicados): 4
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publication Artículo científico (JournalArticle)

Properties of LZS/nanoAl2O3 glass-ceramic composites

  • Arcaro, S.
  • Moreno, B.
  • Chinarro, E.
  • Nieto, M.I.
  • Moreno, R.
  • Novaes de Oliveira, A.P.
  • Salvador Moya, Mª Dolores|||0000-0002-4242-478X
  • Borrell Tomás, María Amparo|||0000-0003-4292-4538
[EN] The LZS glass-ceramic (19.58 Li2O center dot 11.10ZrO(2)center dot 69.32SiO(2)) have a high coefficient thermal expansion (CTE) which can be a limitation in some applications. The addition of alumina in a LZS glass-ceramic matrix is able to reduce the CTE significantly. This happens because of the alumina affinity with respect to lithium silicates to form beta-spodumene (LiAlSi2O6), a crystalline phase having a CTE nearly zero (0.9 x 10(-6) degrees C-1).In this work, (1-5 vol%) Al2O3 nanoparticles (13 nm) were added to a LZS (3.5 mu m) glass-ceramic matrix to prepare composites with the main goal of evaluation the influence of Al2O3 on their mechanical, thermal and electrical properties. Each composition was wet homogenized and then dried at 110 degrees C for 48 h for disaggregation. The composites, sintered at 900 degrees C for 30 min, with relative densities between 92% and 98%, showed zircon and beta-spodumene as main crystalline phases. The incorporation of increasing additions of nanosized alumina progressively decreases the final density. This makes the properties to slightly decrease, also. The Young's modulus significantly decreases from 111 to 78 GPa of hardness due to the exponential variation with porosity, but the changes of toughness and hardness are much lower. The electrical conductivity was maintained within +/- 10-7 S. cm(-1), and the dielectric constant ranged from 5 to 6 for all compositions. Thermal conductivity ranged around 4.2 to 3.5 W/mK. (C) 2017 Elsevier B.V. All rights reserved., This work has been supported by CAPES in the frame of the International Cooperation Program Science without Borders for Special Visiting Researcher PVE (MEC/MCTI/CAPES/CNPq/FAPs/ No 71/2013), Project No A011/2013 (Brazil) and CNPq (National Council for Scientific and Technological Development, Brazil). This work has been also supported by Ministerio de Economia y Cornpetitividad and FEDER Funds under grant No MAT2016-67586-C3-R and grant ENE2013-49111-C2-1-R. A. Borrell acknowledges the MINECO for her Juan de la Cierva-Incorporacion contract (IJCI-2014-19839).
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Contribución de congreso (ConferenceOutput)

Hybrid membranes with improved methanol crossover for DMFCs applications

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

Processing and electrical conductivity of non-stoichiometric lanthanum strontium manganite perovskites prepared from powders synthesized by a polymerizable-complexation route

  • Colomer, María T.
  • Chinarro Martín, Eva
  • Ortiz, Ángel L.
[EN] Perovskite ceramics with non-stoichiometric compositions given by (LaSr)MnO ((LS)M-85) and (LaSr)MnO ((LS)M-80) were obtained by pressureless sintering (1500 °C for 2 h) from powders synthesized by a polymerizable-complexation route and then calcined (500 °C for 1 h). It was found that the two sintered ceramics contain trigonal (i.e., R3̅c) Sr-doped lanthanum manganite as majority phase, and also hexagonal (i.e., P6/m) La(OH) in trace amounts in the case of (LS)M-85 and in abundant amounts in the case of (LS)M-80. The (LS)M-85 ceramic is stable and therefore usable, whereas on the contrary the (LS)M-80 ceramic eventually swelled and turned into a powder due to the abundant La(OH) that uptakes water from the atmosphere. Finally, it was found that the (LS)M-85 ceramic has appropriate electrical properties for use as cathode in solid oxide fuel cells, with a total conductivity of ~ 145 S/cm at 1000 °C and an activation energy of 0.067(2) eV., This work was supported by MINECO (Government of Spain) and Feder Funds under Grants no. MAT2016-78700-R, MAT2016-76638-R and ENE2013-49111-C2-1-R. The authors also acknowledge to Mrs. M. Fernández and Mrs. R. Navidad for their experimental help, and to Mrs. C. Díaz-Dorado for her help in the preparation of figures.
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

40SiO2–40P2O5–20ZrO2 sol-gel infiltrated sSEBS membranes with improved methanol crossover and cell performance for direct methanol fuel cell applications

  • Santiago, O.
  • Mosa Ruiz, Jadra
  • Navarro, Elena
  • Chinarro Martín, Eva
  • Aparicio, Mario
  • Leo, T. J.
  • Del Río, C.
Membranes commonly used in direct methanol fuel cell (DMFC) are expensive and show a great permeability to methanol which reduces fuel utilization and leads to mixed potential at the cathode. In this work, sulfonated styrene-ethylene-butylene-styrene (sSEBS) modified membranes with zirconia silica phosphate sol-gel phase are developed and studied in order to evaluate their potential use in DMFC applications. The synthesized hybrid membranes and sSEBS are subjected to an exhaustive physicochemical characterization by liquid uptake, ion exchange capacity, atomic force microscopy, X-ray photoelectron spectroscopy and dynamic mechanical and thermogravimetric analyses. Likewise, the potential use of the prepared membranes in DMFC is evaluated by means of electrochemical characterizations in single cell, determining the limiting methanol crossover current densities, proton conductivities and DMFC performances. The hybrid membranes show lower water and methanol uptakes, higher stiffness, water retention capability, upper power density and lower methanol crossover than sSEBS and Nafion 112., The authors would like to acknowledge Comunidad de Madrid and European Social Fund (ESF) through the Project S2013/MAE-2975 PILCONAER. The Spanish Ministry of Economy, Industry and Competitiveness is also thanked for the Research Projects MINECO ENE2013-49111-C2-1-R, ENE2014-53734-C2-2-R, ENE2017-86711-C3-1-R, ENE2017-86711-C3-2-R and ENE2017-90932-REDT