DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication
Artículo científico (JournalArticle)
High thermoelectric performance in crystallographically textured n-type Bi2Te3–xSex produced from asymmetric colloidal nanocrystals
In the present work, we demonstrate crystallographically textured n-type Bi2Te3–xSex nanomaterials with exceptional thermoelectric figures of merit produced by consolidating disk-shaped Bi2Te3–xSex colloidal nanocrystals (NCs). Crystallographic texture was achieved by hot pressing the asymmetric NCs in the presence of an excess of tellurium. During the hot press, tellurium acted both as lubricant to facilitate the rotation of NCs lying close to normal to the pressure axis and as solvent to dissolve the NCs approximately aligned with the pressing direction, which afterward recrystallize with a preferential orientation. NC-based Bi2Te3–xSex nanomaterials showed very high electrical conductivities associated with large charge carrier concentrations, n. We hypothesize that such large n resulted from the presence of an excess of tellurium during processing, which introduced a high density of donor TeBi antisites. Additionally, the presence in between grains of traces of elemental Te, a narrow band gap semiconductor with a work function well below Bi2Te3–xSex, might further contribute to increase n through spillover of electrons, while at the same time blocking phonon propagation and hole transport through the nanomaterial. NC-based Bi2Te3–xSex nanomaterials were characterized by very low thermal conductivities in the pressing direction, which resulted in ZT values up to 1.31 at 438 K in this direction. This corresponds to a ca. 40% ZT enhancement from commercial ingots. Additionally, high ZT values were extended over wider temperature ranges due to reduced bipolar contribution to the Seebeck coefficient and the thermal conductivity. Average ZT values up to 1.15 over a wide temperature range, 320 to 500 K, were measured, which corresponds to a ca. 50% increase over commercial materials in the same temperature range. Contrary to most previous works, highest ZT values were obtained in the pressing direction, corresponding to the c crystallographic axis, due to the predominance of the thermal conductivity reduction over the electrical conductivity difference when comparing the two crystal directions., This work was supported by the European Regional Development Funds. Y.L. and Y.Z. thank the China Scholarship Council for scholarship support. M.V.K. acknowledges partial financial support by the European Union (EU) via FP7 ERC Starting Grant 2012 (Project NANOSOLID, GA no. 306733). S.M.S. acknowledges funding from “Programa Internacional de Becas “la Caixa”-Severo Ochoa”. J.D. acknowledges funding from the European Union’s Horizon 2020 research and innovation program under the Marie Sklodowska-Curie grant agreement no. 665919. ICN2 acknowledges funding from Generalitat de Catalunya 2017 SGR 327 and IREC from 2017 SGR 1246. ICN2 members acknowledge support from the Severo Ochoa Programme (MINECO, grant no. SEV-2013-0295) and is funded by the CERCA Programme/Generalitat de Catalunya. J.A., S.M.S., and J.D. acknowledge funding from MINECO subproject ANAPHASE (ENE2017-85087-C3)., Peer reviewed
Project:
EC / FP7 306733
,
AEI / Plan Estatal de Investigación Científica y Técnica y de Innovación 2013-2016 ENE2017-85087-C3-1-R
,
EC / H2020 665919
,
MINECO / Plan Estatal de Investigación Científica y Técnica y de Innovación 2013-2016 SEV-2013-0295
,
AEI / Plan Estatal de Investigación Científica y Técnica y de Innovación 2017-2020 ENE2017-85087-C3
,
AEI / Plan Estatal de Investigación Científica y Técnica y de Innovación 2013-2016 ENE2017-85087-C3-2-R
,
AEI / Plan Estatal de Investigación Científica y Técnica y de Innovación 2013-2016 ENE2017-85087-C3-3-R
View at: http://hdl.handle.net/10261/199446