Pasar al contenido principal

ENSAMBLAJE DE NUEVOS COMPUESTOS ORGANOMETALICOS PARA LA FABRICACION DE DISPOSITIVOS ELECTRONICOS POR MEDIO DE LA TECNICA DE LANGMUIR-BLODGETT Y OTROS METODOS DE ABAJO A ARRIBA

CTQ2012-33198

•
Nombre agencia financiadora Ministerio de Economía y Competitividad
Acrónimo agencia financiadora MINECO
Programa Programa Nacional de Proyectos de Investigación Fundamental
Subprograma Subprograma de Proyectos de Investigación Fundamental no Orientada
Convocatoria Proyectos I+D
Año convocatoria 2012
Plan Estatal 2008-2011 Plan Nacional de Investigación Científica, Desarrollo e Innovación Tecnológica
Unidad de gestión Secretaría de Estado de Investigación, Desarrollo e Innovación
Centro beneficiario UNIVERSIDAD DE ZARAGOZA
Identificador persistente http://dx.doi.org/10.13039/501100003329

Resultados relacionados

Resultados totales (Incluyendo duplicados): 6
Encontrada(s) 1 página(s)

Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Electrical characterization of single molecule and Langmuir–Blodgett monomolecular films of a pyridine-terminated oligo(phenylene-ethynylene) derivative

  • Osorio, Henrry M.
  • Martin, Santiago
  • Lopez, María Carmen
  • Marqués-González, Santiago
  • Higgins, Simon J.
  • Nichols, Richard J.
  • Low, Paul L.
  • Cea, Pilar
Monolayer Langmuir–Blodgett (LB) films of 1,4-bis(pyridin-4-ylethynyl)benzene (1) together with the “STM touch-to-contact” method have been used to study the nature of metal–monolayer–metal junctions in which the pyridyl group provides the contact at both molecule–surface interfaces. Surface pressure vs area per molecule isotherms and Brewster angle microscopy images indicate that 1 forms true monolayers at the air–water interface. LB films of 1 were fabricated by deposition of the Langmuir films onto solid supports resulting in monolayers with surface coverage of 0.98 × 10-9 mol·cm-2. The morphology of the LB films that incorporate compound 1 was studied using atomic force microscopy (AFM). AFM images indicate the formation of homogeneous, monomolecular films at a surface pressure of transference of 16 mN·m-1. The UV–vis spectra of the Langmuir and LB films reveal that 1 forms two dimensional J-aggregates. Scanning tunneling microscopy (STM), in particular the “STM touch-to-contact” method, was used to determine the electrical properties of LB films of 1. From these STM studies symmetrical I–V curves were obtained. A junction conductance of 5.17 × 10-5 G0 results from the analysis of the pseudolinear (ohmic) region of the I–V curves. This value is higher than that of the conductance values of LB films of phenylene-ethynylene derivatives contacted by amines, thiols, carboxylate, trimethylsilylethynyl or acetylide groups. In addition, the single molecule I–V curve of 1 determined using the I(s) method is in good agreement with the I–V curve obtained for the LB film, and both curves fit well with the Simmons model. Together, these results not only indicate that the mechanism of transport through these metal–molecule–metal junctions is non-reso- nant tunneling, but that lateral interactions between molecules within the LB film do not strongly influence the molecule conduc- tance. The results presented here complement earlier studies of single molecule conductance of 1 using STM-BJ methods, and support the growing evidence that the pyridyl group is an efficient and effective anchoring group in sandwiched metal–monolayer–metal junctions prepared under a number of different conditions.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Fabrication of ultrathin films containing the metal organic framework Fe-MIL-88B-NH2 by the Langmuir-Blodgett technique

  • Benito, J.
  • Fenero, M.
  • Sorribas, S.
  • Zornoza, B.
  • Msayib, K.J.
  • McKeown, N.B.
  • Téllez, C.
  • Coronas, J.
  • Gascón, I.
In this work, the fabrication of ultrathin films containing the metal organic framework (MOF) Fe-MIL- 88B-NH2 by the Langmuir–Blodgett (LB) technique has been explored. MOF crystals of two different sizes (1.5 ± 0.3 and 0.07 ± 0.01 µm) have been synthesized and assembled at the air–liquid interface by the LB method. The effect of the subphase pH and particle size on the film formation process has been studied. Moreover, for the first time, mixed MOF+polymer (the commercial soluble polyimide Matrimid®) LB films containing different MOF loadings have been fabricated. These experiments show that it is possible to obtain ultrathin MOF + polymer films with a controlled MOF density. Furthermore, MOF particles are homogeneously distributed in the polymer matrix, even with very large amounts of MOF (up to 95 wt%). LB films have been incorporated into materials of different nature, including glass and mica substrates and also polymeric membranes based on polysulfone Udel® and PIM-1 (polymer of intrinsic microporosity), and the modification of water contact angle after LB film deposition has been analyzed.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Low variability of single-molecule conductance assisted by bulky metal–molecule contacts

  • Ferradas, Ruben R.
  • Marques-Gonzalez, Santiago
  • Osorio, Henrry M.
  • Ferrer, Jaime
  • Cea, Pilar
  • Milan, David C.
  • Vezzoli, Andrea
  • Higgins, Simon J.
  • Nichols, Richard J.
  • Low, Paul J.
  • Garcia-Suarez, Victor M.
  • Martin, Santiago
A detailed study of the trimethylsilylethynyl moiety, –C[triple bond, length as m-dash]CSiMe3 (TMSE), as an anchoring group in metal|molecule|metal junctions, using a combination of experiment and density functional theory is presented. It is shown that the TMSE anchoring group provides improved control over the molecule–substrate arrangement within metal|molecule|metal junctions, with the steric bulk of the methyl groups limiting the number of highly transmissive binding sites at the electrode surface, resulting in a single sharp peak in the conductance histograms recorded by both the in situ break junction and I(s) STM techniques. As a consequence of the low accessibility of the TMSE group to surface binding configurations of measurable conductance, only about 10% of gold break junction formation cycles result in the clear formation of molecular junctions in the experimental histograms. The DFT-computed transmission characteristics of junctions formed from the TMSE-contacted oligo(phenylene)ethynylene (OPE)-based molecules described here are dominated by tunneling effects through the highest-occupied molecular orbitals (HOMOs). This gives rise to similar conductance characteristics in these TMSE-contacted systems as found in low conductance-type junctions based on comparably structured OPE-derivatives with amine-contacts that also conduct through HOMO-based channels.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Towards a metallic top contact electrode in molecular electronic devices exhibiting a large surface coverage by photoreduction of silver cations

  • Martin, Santiago
  • Ballesteros, Luz M.
  • Gonzalez-Orive, A.
  • Oliva, H.
  • Marques-Gonzalez, Santiago
  • Lorenzoni, Matteo
  • Nichols, Richard J.
  • Perez-Murano, Francesc
  • Low, Paul J.
  • Cea, Pilar
In this contribution the photoreduction of silver ions coordinated onto a Langmuir–Blodgett monolayer is presented as an effective method for the deposition of the top contact electrode in metal/monolayer/metal devices. Silver cations were incorporated from an aqueous AgNO3 sub-phase of Langmuir films of 4,4'-(1,4-phenylenebis(ethyne-2,1-diyl))dibenzoic acid upon the transference of these films onto a metallic substrate. Subsequent irradiation of the silver-ion functionalized Langmuir–Blodgett films with 254 nm light results in the photoreduction of silver cations to produce metallic silver nanoparticles, which are distributed over the organic monolayer and exhibit a surface coverage as large as 76% of the monolayer surface. Electrical properties of these metal/monolayer/metal devices were determined by recording I–V curves, which show a sigmoidal behaviour indicative of well-behaved junctions free of metallic filaments and short-circuits. The integrity of the organic monolayer upon the irradiation process and formation of the silver top-contact electrode has also been demonstrated through cyclic voltammetry experiments.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Nanofabrication techniques of highly organized monolayers sandwiched between two electrodes for molecular electronics

  • Cea, P.
  • Ballesteros, L.M.
  • Martín, S.
It is expected that molecular electronics, i.e., the use of molecules as critical functional elements in electronic devices, will lead in the near future to an industrial exploitable novel technology, which will open new routes to high value-added electronic products. However, despite the enormous advances in this field several scientific and technological challenges should be surmounted before molecular electronics can be implemented in the market. Among these challenges are the fabrication of reliable, robust and uniform contacts between molecules and electrodes, the deposition of the second (top) contact electrode, and development of assembly strategies for precise placement of molecular materials within device structures. This review covers advances in nanofabrication techniques used for the assembly of monomolecular films onto conducting or semiconducting substrates as well as recent methods developed for the deposition of the top contact electrode highlighting the advantages and limitations of the several approaches used in the literature. This contribution also aims to define areas of outstanding challenges in the nanofabrication of monomolecular layers sandwiched between two electrodes and opportunities for future research and applications.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Nanofabrication and Electrochemical Characterization of Self-Assembled Monolayers Sandwiched between Metal Nanoparticles and Electrode Surfaces

  • Cea, P.
  • Martín, S.
  • González-Orive, A.
  • Osorio, H.M.
  • Quintín, P.
  • Herrer, L.
Nanoscience and nanotechnology have reached the syllabi of many upper-division undergraduate and master-level courses all over the world. There is therefore a growing need for practical exercises that illustrate the fabrication, characterization, properties, and applications of nanomaterials. Here we describe an advanced-level laboratory experiment in which students had the opportunity to fabricate surfaces modified by ordered monolayers and nanostructured materials. The surface modification was quantified by means of a quartz crystal microbalance, while the electrochemical properties of the nanoarchitectures were assessed using cyclic voltammetry experiments. Electron transfer across self-assembled monolayers mediated by gold nanoparticles was presented as a topic for discussion, and consideration of potential practical applications of the observed phenomena (catalytic and electrocatalytic processes, as well as development of optical, (opto)electronic, and photovoltaic devices with enhanced properties) was proposed as a further reading exercise.