Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 5
Encontrada(s) 1 página(s)

Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Electrical characterization of single molecule and Langmuir–Blodgett monomolecular films of a pyridine-terminated oligo(phenylene-ethynylene) derivative

  • Osorio, Henrry M.
  • Martin, Santiago
  • Lopez, María Carmen
  • Marqués-González, Santiago
  • Higgins, Simon J.
  • Nichols, Richard J.
  • Low, Paul L.
  • Cea, Pilar
Monolayer Langmuir–Blodgett (LB) films of 1,4-bis(pyridin-4-ylethynyl)benzene (1) together with the “STM touch-to-contact” method have been used to study the nature of metal–monolayer–metal junctions in which the pyridyl group provides the contact at both molecule–surface interfaces. Surface pressure vs area per molecule isotherms and Brewster angle microscopy images indicate that 1 forms true monolayers at the air–water interface. LB films of 1 were fabricated by deposition of the Langmuir films onto solid supports resulting in monolayers with surface coverage of 0.98 × 10-9 mol·cm-2. The morphology of the LB films that incorporate compound 1 was studied using atomic force microscopy (AFM). AFM images indicate the formation of homogeneous, monomolecular films at a surface pressure of transference of 16 mN·m-1. The UV–vis spectra of the Langmuir and LB films reveal that 1 forms two dimensional J-aggregates. Scanning tunneling microscopy (STM), in particular the “STM touch-to-contact” method, was used to determine the electrical properties of LB films of 1. From these STM studies symmetrical I–V curves were obtained. A junction conductance of 5.17 × 10-5 G0 results from the analysis of the pseudolinear (ohmic) region of the I–V curves. This value is higher than that of the conductance values of LB films of phenylene-ethynylene derivatives contacted by amines, thiols, carboxylate, trimethylsilylethynyl or acetylide groups. In addition, the single molecule I–V curve of 1 determined using the I(s) method is in good agreement with the I–V curve obtained for the LB film, and both curves fit well with the Simmons model. Together, these results not only indicate that the mechanism of transport through these metal–molecule–metal junctions is non-reso- nant tunneling, but that lateral interactions between molecules within the LB film do not strongly influence the molecule conduc- tance. The results presented here complement earlier studies of single molecule conductance of 1 using STM-BJ methods, and support the growing evidence that the pyridyl group is an efficient and effective anchoring group in sandwiched metal–monolayer–metal junctions prepared under a number of different conditions.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Low variability of single-molecule conductance assisted by bulky metal–molecule contacts

  • Ferradas, Ruben R.
  • Marques-Gonzalez, Santiago
  • Osorio, Henrry M.
  • Ferrer, Jaime
  • Cea, Pilar
  • Milan, David C.
  • Vezzoli, Andrea
  • Higgins, Simon J.
  • Nichols, Richard J.
  • Low, Paul J.
  • Garcia-Suarez, Victor M.
  • Martin, Santiago
A detailed study of the trimethylsilylethynyl moiety, –C[triple bond, length as m-dash]CSiMe3 (TMSE), as an anchoring group in metal|molecule|metal junctions, using a combination of experiment and density functional theory is presented. It is shown that the TMSE anchoring group provides improved control over the molecule–substrate arrangement within metal|molecule|metal junctions, with the steric bulk of the methyl groups limiting the number of highly transmissive binding sites at the electrode surface, resulting in a single sharp peak in the conductance histograms recorded by both the in situ break junction and I(s) STM techniques. As a consequence of the low accessibility of the TMSE group to surface binding configurations of measurable conductance, only about 10% of gold break junction formation cycles result in the clear formation of molecular junctions in the experimental histograms. The DFT-computed transmission characteristics of junctions formed from the TMSE-contacted oligo(phenylene)ethynylene (OPE)-based molecules described here are dominated by tunneling effects through the highest-occupied molecular orbitals (HOMOs). This gives rise to similar conductance characteristics in these TMSE-contacted systems as found in low conductance-type junctions based on comparably structured OPE-derivatives with amine-contacts that also conduct through HOMO-based channels.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Towards a metallic top contact electrode in molecular electronic devices exhibiting a large surface coverage by photoreduction of silver cations

  • Martin, Santiago
  • Ballesteros, Luz M.
  • Gonzalez-Orive, A.
  • Oliva, H.
  • Marques-Gonzalez, Santiago
  • Lorenzoni, Matteo
  • Nichols, Richard J.
  • Perez-Murano, Francesc
  • Low, Paul J.
  • Cea, Pilar
In this contribution the photoreduction of silver ions coordinated onto a Langmuir–Blodgett monolayer is presented as an effective method for the deposition of the top contact electrode in metal/monolayer/metal devices. Silver cations were incorporated from an aqueous AgNO3 sub-phase of Langmuir films of 4,4'-(1,4-phenylenebis(ethyne-2,1-diyl))dibenzoic acid upon the transference of these films onto a metallic substrate. Subsequent irradiation of the silver-ion functionalized Langmuir–Blodgett films with 254 nm light results in the photoreduction of silver cations to produce metallic silver nanoparticles, which are distributed over the organic monolayer and exhibit a surface coverage as large as 76% of the monolayer surface. Electrical properties of these metal/monolayer/metal devices were determined by recording I–V curves, which show a sigmoidal behaviour indicative of well-behaved junctions free of metallic filaments and short-circuits. The integrity of the organic monolayer upon the irradiation process and formation of the silver top-contact electrode has also been demonstrated through cyclic voltammetry experiments.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

All-Carbon Electrode Molecular Electronic Devices Based on Langmuir–Blodgett Monolayers

  • Sangiao, S.
  • Martín, S.
  • González-Orive, A.
  • Magén, C.
  • Low, P.J.
  • De Teresa, J.M.
  • Cea, P.
Nascent molecular electronic devices, based on monolayer Langmuir–Blodgett films sandwiched between two carbonaceous electrodes, have been prepared. Tightly packed monolayers of 4-((4-((4-ethynylphenyl)ethynyl)phenyl)ethynyl)benzoic acid are deposited onto a highly oriented pyrolytic graphite electrode. An amorphous carbon top contact electrode is formed on top of the monolayer from a naphthalene precursor using the focused electron beam induced deposition technique. This allows the deposition of a carbon top-contact electrode with well-defined shape, thickness, and precise positioning on the film with nm resolution. These results represent a substantial step toward the realization of integrated molecular electronic devices based on monolayers and carbon electrodes.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Nanofabrication and Electrochemical Characterization of Self-Assembled Monolayers Sandwiched between Metal Nanoparticles and Electrode Surfaces

  • Cea, P.
  • Martín, S.
  • González-Orive, A.
  • Osorio, H.M.
  • Quintín, P.
  • Herrer, L.
Nanoscience and nanotechnology have reached the syllabi of many upper-division undergraduate and master-level courses all over the world. There is therefore a growing need for practical exercises that illustrate the fabrication, characterization, properties, and applications of nanomaterials. Here we describe an advanced-level laboratory experiment in which students had the opportunity to fabricate surfaces modified by ordered monolayers and nanostructured materials. The surface modification was quantified by means of a quartz crystal microbalance, while the electrochemical properties of the nanoarchitectures were assessed using cyclic voltammetry experiments. Electron transfer across self-assembled monolayers mediated by gold nanoparticles was presented as a topic for discussion, and consideration of potential practical applications of the observed phenomena (catalytic and electrocatalytic processes, as well as development of optical, (opto)electronic, and photovoltaic devices with enhanced properties) was proposed as a further reading exercise.