Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 4
Encontrada(s) 1 página(s)

Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Ultrathin tungsten films enabling enhanced electrical response to spin currents

  • Morales-Aragonés, José Ignacio
  • Groen, Inge
  • Hueso, Luis E
  • Casanova, Fèlix
  • Pardo, José Ángel
  • Sánchez-Azqueta, Carlos
  • De Teresa, José María
  • Sangiao, Soraya
The efficient detection of spin currents is crucial for the development of next-generation spintronic devices. Here, we demonstrate that ultrathin W layers, with thicknesses down to 2 nm—equivalent to only four atomic planes—allow for highly efficient spin-to-charge conversion. From spin pumping experiments in YIG/W bilayers, we analyzed the inverse spin Hall effect (SHE) voltage dependence on W thickness and extracted a spin Hall conductivity of σSH = −1.14(6) × 105 Ω −1 m−1, yielding effective spin Hall angles ranging from −0.27(4) to −0.88(4) over the investigated thickness range. Furthermore, assuming the Elliott–Yafet spin scattering mechanism dominates, we estimate a spin diffusion length λsd = 4.3(5) × 10−15Ωm2/ρW, where the W resistivity ρW is strongly dependent on thickness. Structural characterization, together with roomtemperature electrical resistivity measurements and the high spin-to-charge conversion efficiency observed, confirms the stabilization of the β-phase in these ultrathin W layers. We demonstrate that the monotonic increase of the inverse SHE voltage with decreasing W thickness persists down to 2-nm-thick W layer, reflecting the extremely short spin diffusion length. This allows for efficient spin-current detection in W layers below 5 nm, effectively doubling the voltage output at half the thickness. In the thinnest sample, a continuous 2-nm-thick W layer, the generated voltage exceeds 0.5 mV—well within the operating range of conventional electronics. These findings demonstrate not only the feasibility of spin-current detection in ultrathin W, but also its compatibility with conventional electronics. They highlight the strong potential of integrating ultrathin W layers with high-quality YIG films for the development of energy-efficient spintronic devices and sensors.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Application of Ag-Enriched Nanostructures Through Ga+ Irradiation of Silver Butyrate Films in Surface-Enhanced Raman Spectroscopy (SERS)

  • Ocaña-Parral, Juan Ignacio
  • Herrer, Lucía
  • Tejedor, Inés
  • Salvador-Porroche, Alba
  • Barth, Sven
  • Cea, Pilar
  • Sangiao, Soraya
  • De Teresa, José María
Spin-coated films based on silver butyrate precursor solutions are submitted to focused Ga+ irradiation for the direct fabrication of Ag-enriched nanostructures. We report that, through the optimization of the solutions’ concentration, the spin-coating conditions, and the irradiation parameters, Ag-enriched patterned films with a tunable microstructure are obtained. In the case of a microstructure consisting of large and continuous Ag-enriched platelets, the patterned film is metallic, with resistivity down to 90 µΩ·cm. In the case of a microstructure consisting of small and discontinuous Ag-enriched nanoparticles, the corresponding patterned film is found to be suitable as a Surface-Enhanced Raman Spectroscopy (SERS) substrate. As proof of concept, the SERS signals produced by thiophenol solutions are measured and compared to a rough Ag film grown by sputtering, leading to a 200 times higher signal. Given the low Ga+ irradiation fluence required to produce tunable Ag nanostructures with metallic or SERS functionality, the obtained results highlight the potential of silver butyrate precursor solutions for the high-throughput printing of a nanomaterial with applications in nanoelectronics (metallic interconnects) and nanophotonics (SERS substrates).
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Vortex Domain Wall Imaging in a 3D Magnetic Nanotube Grown by Focused Electron Beam Induced Deposition

  • Pablo-Navarro, Javier
  • Rodríguez, Luis Alfredo
  • Gatel, Christophe
  • Andersen, Ingrid Marie
  • Snoeck, Etienne
  • De Teresa, José María
  • Magén, César
Theoretical predictions present the magnetic nanotube (MNT) as an ideal physical implementation for 3D spintronic devices due to the unique magnetization dynamics, with stable and fast domain wall (DW) motion beyond the Walker limit, given by its coreless curved topology. However, due to this heterogeneous architecture and the need to combine different synthetic methods, experimental realizations of nanometer‐size MNTs are scarce and technically complex. Here, we report for the first time the fabrication of nanometer‐scale 3D Co MNTs, synthesized by a single growth technique, namely focused electron beam induced deposition (FEBID), and thermally annealed in vacuum. Quantitative magnetic imaging of the remanent state and DW structure of a 10‐nm‐thick cylindrical Co nanotube grown on a 70‐nm‐wide vertical Pt–C nanowire template, carried out by off‐axis electron holography in an aberration‐corrected Lorentz (field‐free) transmission electron microscope, reveals the nucleation and pinning of a head‐to‐head tilted vortex DW, whose structure has been confirmed by detailed micromagnetic simulations. The direct experimental evidence of such spin configuration stabilized in MNTs opens new venues for the investigation of curvature‐driven spin textures and new technologies based on 3D nanomagnets.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Substrate compatibility of Cryo-FIBID processes with the Co2(CO)8 precursor

  • Escalante-Quiceno, A. T.
  • Magén, C.
  • De Teresa, J. M.
Cryo-FIBID (focused ion beam induced deposition at cryogenic conditions) is an advanced nanofabrication technique that enables the controlled deposition of materials with high spatial resolution by condensing a precursor on a cooled substrate before ion beam irradiation. In this study, Cryo-FIBID using a Ga+ source and the Co2(CO)8 precursor was used to deposit cobalt layers on a variety of substrates, including metals, semiconductors, insulators, and graphene, without the need for conductive coatings on insulating surfaces. The microstructural and compositional properties of the deposits were probed by means of several microscopy techniques, which indicate that the deposits consist of homogeneous and compact cobalt-based thin layers. The investigation has revealed that two deposition parameters, the initial thickness of the condensed precursor layer and the Ga+ irradiation fluence, have a significant impact on the composition, microstructure and thickness of the final deposit. Interestingly, it was found that the cobalt content in the grown deposits depends strongly on the substrate material. Whereas deposits with a high cobalt content ( 60 at.%) are produced on Si, Au and Al substrates, the use of SiO2, graphene and SrTiO3 substrates gives rise to deposits with a lower cobalt content ( 40 at.%). The set of results highlights the versatility of Cryo-FIBID toward the growth of patterned cobalt-based structures on a wide range of substrates.