Pasar al contenido principal

FOTONICA INTEGRADA ULTRARRAPIDA

FIS2017-87970-R

•
Nombre agencia financiadora Agencia Estatal de Investigación
Acrónimo agencia financiadora AEI
Programa Programa Estatal de I+D+i Orientado a los Retos de la Sociedad
Convocatoria Proyectos I+D+i Retos de Investigación
Año convocatoria 2017
Plan Estatal 2017-2020 Plan Estatal de Investigación Científica y Técnica y de Innovación
Centro beneficiario UNIVERSIDAD DE SALAMANCA

Resultados relacionados

Resultados totales (Incluyendo duplicados): 5
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Improved crack resistance and thermal conductivity of cubic zirconia containing graphene nanoplatelets

  • Gómez-Gómez, Alberto
  • Ramírez, Cristina
  • Llorente, Javier
  • García, Ana
  • Moreno, Pablo
  • Reveron, Helen
  • Chevalier, Jérôme
  • Osendi, María Isabel
  • Belmonte, Manuel
  • Miranzo López, Pilar
[EN] Composites of 8 mol.% yttria-stabilized zirconia (8YSZ) with graphene nanoplatelets (GNP) have been pointed as alternative interconnectors in SOFC due to their mixed ionic-electronic conduction. Here we show that GNP addition provides rising crack-resistance behavior, with long crack toughness up to 78% higher than that of 8YSZ, also improving its thermal conductivity (up to 6 times for the in-plane direction). Toughness versus crack length is measured for 7 and 11 vol.% of GNP using single edge V-notched beam technique and ultrashort pulsed laser notching; and thermal behavior is analyzed by the laser flash method. Materials also have highly anisotropic coefficient of thermal expansion. These properties contribute to enhance their performance under the harsh operating conditions of SOFC, as thermal residual stresses could be reduced while significantly improving the system mechanical stability. Moreover, the heat transfer may be enhanced especially along the interface direction which would increase the system efficiency., This work was supported by Spanish project RTI2018-095052-B-I00, Ministerio de Ciencia, Innovacion y Universidades, Spain (MCIU/AEI/FEDER, UE). AG and PM acknowledge support from Ministerio de Economía, Industria y Competitividad, Spanish government (Project FIS2017- 87970-R) and Junta de Castilla y León, Spain (Project SA287P18). C. R. thanks the financial support by MCIU under contract IJCI-2017-34724 of “Juan de la Cierva” Program., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Laser-Induced Periodic Surface Structuring of Poly(trimethylene terephthalate) Films Containing Tungsten Disulfide Nanotubes

  • Prada-Rodrigo, Javier
  • Rodríguez-Beltrán, René, I.
  • Paszkiewicz, S.
  • Szymczyk, A.
  • Ezquerra, Tiberio A.
  • Moreno, Pablo
  • Rebollar, Esther
© 2020 by the authors., We report the study of the formation of Laser Induced Periodic Surface Structures (LIPSS), with UV femtosecond laser pulses (λ = 265 nm), in free-standing films of both Poly(trimethylene terephthalate) (PTT) and the composite PTT/tungsten disulfide inorganic nanotubes (PTT-WS2). We characterized the range of fluences and number of pulses necessary to induce LIPSS formation and measured the topography of the samples by Atomic Force Microscopy, the change in surface energy and contact angle using the sessile drop technique, and the modification in both Young’s modulus and adhesion force values with Peak Force-Quantitative Nanomechanical Mapping. LIPSS appeared parallel to the laser polarization with a period close to its wavelength in a narrow fluence and number of pulses regime, with PTT-WS2 needing slightly larger fluence than raw PTT due to its higher crystallinity and heat diffusion. Little change was found in the total surface energy of the samples, but there was a radical increase in the negative polar component (γ−). Besides, we measured small variations in the samples Young’s modulus after LIPSS formation whereas adhesion is reduced by a factor of four. This reduction, as well as the increase in γ−, is a result of the modification of the surface chemistry, in particular a slight oxidation, during irradiation., This work has been supported by the Spanish Ministry of Science and Innovation by the projects MAT2015-66443-C02-1-R (MINECO/FEDER, UE), CTQ2016-75880-P (AEI/FEDER, UE) and FIS2017-87970-R. J.P.-R and P.M. acknowledge support from Junta de Castilla y León (Project SA287P18). J.P.-R thanks the Spanish Ministry of Universities for the FPU grant with reference: FPU17/01859., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Femtosecond laser direct inscription of 3D photonic devices in Er/Yb-doped oxyfluoride nano-glass ceramics

  • Vázquez de Aldana, Javier R.
  • Romero, Carolina
  • Fernández, Joaquín
  • Gorni, Giulio
  • Pascual, M. Jesús
  • Durán, Alicia
  • Balda, Rolindes
The fabrication of optical waveguides by direct femtosecond laser irradiation in Er3+/Yb3+ oxyfluoride nano-glass ceramics is investigated. Following the strategy of single line irradiation, a wide range of laser parameters can be used to obtain single-mode waveguides with nearly-gaussian modal profiles, in the visible and near-infrared. Measured propagation loss is 1.6 dB/cm for the optimum parameters (0.34 μJ/pulse and 20 μm/s scanning velocity), with no annealing after irradiation, and the induced refractive index contrast is Δn∼0.006 (at 800 nm). The multi-scan technique is used to gain control of the refractive index profiles thus producing multimodal structures. The active behavior of the waveguides is induced under ∼800 nm seeding and the co-propagating guidance of the erbium emission is demonstrated. The integration of photonic elements such as Y-splitters, both in 2D and 3D, as well as Mach-Zehnder interferometers, is also shown. Results demonstrate the optimum behavior of Er3+/Yb3+ oxyfluoride nano-glass ceramics as a host material for the integration of complex active photonic devices by femtosecond laser irradiation in the low repetition rate regime., Ministerio de Economía y Competitividad (FIS2017-87970R, MAT2017-87035-C2-1-P/-2-P); Consejería de Educación, Junta de Castilla y León (SA287P18); Euskal Herriko Unibertsitatea (GIU17/014); Eusko Jaurlaritza (PIBA2018-24)., Peer reviewed
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Single-shot d-scan technique for ultrashort laser pulse characterization using transverse second-harmonic generation in random nonlinear crystals

  • Salgado-Remacha, F.J.
  • Alonso, B.
  • Crespo, H.
  • Cojocaru, C.
  • Trull, J.
  • Romero, R.
  • Lopez-Ripa, M.
  • Guerreiro, P.T.
  • Silva, F.
  • Miranda, M.
  • L''Huillier, A.
  • Arnold, C.L.
  • Sola, I.J.
We demonstrate a novel dispersion-scan (d-scan) scheme for single-shot temporal characterization of ultrashort laser pulses. The novelty of this method relies on the use of a highly dispersive crystal featuring antiparallel nonlinear domains with a random distribution and size. This crystal, capable of generating a transverse second-harmonic signal, acts simultaneously as the dispersive element and the nonlinear medium of the d-scan device. The resulting in-line architecture makes the technique very simple and robust, allowing the acquisition of single-shot d-scan traces in real time. The retrieved pulses are in very good agreement with independent frequency-resolved optical grating measurements. We also apply the new single-shot d-scan to a terawatt-class laser equipped with a programmable pulse shaper, obtaining an excellent agreement between the applied and the d-scan retrieved dispersions.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Coherent artifact and time-dependent polarization in amplified ultrafast erbium-doped fibre lasers

  • López-Ripa, M.
  • Alonso, B.
  • Jarabo, S.
  • Salgado-Remacha, F.J.
  • Aguado, J.C.
  • Sola, Í.J.
Mode-locked erbium-doped fibre lasers are ultrashort pulsed sources widely studied due to their versatility and multiple applications in the near infrared range. Here we present the experimental study of the emission of a passive mode-locked erbium-doped fibre laser with an amplification stage outside the cavity by means of Frequency Resolved Optical Gating (FROG) and spectral interferometry. Due to shot-to-shot instabilities, the FROG traces can be understood as the combination of two different traces, corresponding to the coherent artifact and the average pulse characteristics. We have modified a Principal Components Generalized Projections Algorithm, in order to make it able to retrieve efficiently both the coherent artifact and the average pulse. In addition, we study the temporal dependence of the polarization, showing that the pulses present time-dependent polarization with a stable spectral relative phase between the horizontal and vertical projections. Up to our knowledge, this is the first experimental study that shows the FROG measurements of unstable pulse trains associated with the coherent artifact and analyses the time-dependent polarization in ultrafast fibre lasers.