Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 5
Encontrada(s) 1 página(s)

Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Highly-efficient growth of cobalt nanostructures using focused ion beam induced deposition under cryogenic conditions: Application to electrical contacts on graphene, magnetism and hard masking

  • Salvador-Porroche A.
  • Sangiao S.
  • Magén C.
  • Barrado M.
  • Philipp P.
  • Belotcerkovtceva D.
  • Kamalakar M.V.
  • Cea P.
  • Teresa J.M. de
Emergent technologies are required in the field of nanoelectronics for improved contacts and interconnects at nano and micro-scale. In this work, we report a highly-efficient nanolithography process for the growth of cobalt nanostructures requiring an ultra-low charge dose (15 µC cm-2, unprecedented in single-step charge-based nanopatterning). This resist-free process consists in the condensation of a ~28 nm-thick Co2(CO)8 layer on a substrate held at -100 °C, its irradiation with a Ga+ focused ion beam, and substrate heating up to room temperature. The resulting cobalt-based deposits exhibit sub-100 nm lateral resolution, display metallic behaviour (room-temperature resistivity of 200 µO cm), present ferromagnetic properties (magnetization at room temperature of 400 emu cm-3) and can be grown in large areas. To put these results in perspective, similar properties can be achieved by room-temperature focused ion beam induced deposition and the same precursor only if a 2 × 103 times higher charge dose is used. We demonstrate the application of such an ultra-fast growth process to directly create electrical contacts onto graphene ribbons, opening the route for a broad application of this technology to any 2D material. In addition, the application of these cryo-deposits for hard masking is demonstrated, confirming its structural functionality. This journal is © The Royal Society of Chemistry.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Reseña (Review)

Superconducting materials and devices grown by focused ion and electron beam induced deposition

  • Orús, P.
  • Sigloch, F.
  • Sangiao, S.
  • Teresa, J. M. de
Since its discovery in 1911, superconductivity has represented an equally inciting and fascinating field of study in several areas of physics and materials science, ranging from its most fundamental theoretical understanding, to its practical application in different areas of engineering. The fabrication of superconducting materials can be downsized to the nanoscale by means of Focused Ion/Electron Beam Induced Deposition: nanopatterning techniques that make use of a focused beam of ions or electrons to decompose a gaseous precursor in a single step. Overcoming the need to use a resist, these approaches allow for targeted, highly-flexible nanopatterning of nanostructures with lateral resolution in the range of 10 nm to 30 nm. In this review, the fundamentals of these nanofabrication techniques are presented, followed by a literature revision on the published work that makes use of them to grow superconducting materials, the most remarkable of which are based on tungsten, niobium, molybdenum, carbon, and lead. Several examples of the application of these materials to functional devices are presented, related to the superconducting proximity effect, vortex dynamics, electric-field effect, and to the nanofabrication of Josephson junctions and nanoSQUIDs. Owing to the patterning flexibility they offer, both of these techniques represent a powerful and convenient approach towards both fundamental and applied research in superconductivity. © 2022 by the authors. Licensee MDPI, Basel, Switzerland.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Critical current modulation induced by an electric field in superconducting tungsten-carbon nanowires

  • Orus, P
  • Fomin, VM
  • De Teresa, JM
  • Cordoba, R
The critical current of a superconducting nanostructure can be suppressed by applying an electric field in its vicinity. This phenomenon is investigated throughout the fabrication and electrical characterization of superconducting tungsten-carbon (W-C) nanostructures grown by Ga+ focused ion beam induced deposition (FIBID). In a 45 nm-wide, 2.7 mu m-long W-C nanowire, an increasing side-gate voltage is found to progressively reduce the critical current of the device, down to a full suppression of the superconducting state below its critical temperature. This modulation is accounted for by the squeezing of the superconducting current by the electric field within a theoretical model based on the Ginzburg-Landau theory, in agreement with experimental data. Compared to electron beam lithography or sputtering, the single-step FIBID approach provides with enhanced patterning flexibility and yields nanodevices with figures of merit comparable to those retrieved in other superconducting materials, including Ti, Nb, and Al. Exhibiting a higher critical temperature than most of other superconductors, in which this phenomenon has been observed, as well as a reduced critical value of the gate voltage required to fully suppress superconductivity, W-C deposits are strong candidates for the fabrication of nanodevices based on the electric field-induced superconductivity modulation.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Superconducting W-C nanopillars fabricated by Ga+ focused ion beam induced deposition

  • Orús, Pablo
  • Sigloch, Fabian
  • Sangiao, Soraya
  • De Teresa, José María
Ga+ Focused Ion Beam Induced Deposition (FIBID) is a highly flexible, single-step nanopatterning technique that makes use of a focused beam of Ga+ ions to locally induce the decomposition of a gaseous precursor material. In combination with the W(CO)6 precursor, Ga+ FIBID is known to yield a W–C compound that is superconducting below 4.7 ​K. While most reports on Ga+ FIBID-grown W–C focus on in-plane patterning, we demonstrate here that growth along the vertical direction may also be achieved by successively stacking a series of individual patterns that get deposited on top of each other. The nanopillars obtained following this procedure reach up to 10 ​μm in height, and have an aspect ratio of around 50. They exhibit a 68% of metallic W in terms of atomic content, higher than the 40% detected in their in-plane counterparts, while maintaining the superconducting properties. This approach also opens up the possibility of tuning their height and growth angle with respect to the substrate, exhibiting potential applicability in the design of 3D superconducting devices.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Nanoscale direct-write fabrication of superconducting devices for application in quantum technologies

  • De Teresa, José María
In this Perspective article, we evaluate the current state of research on the use of focused electron and ion beams to directly fabricate nanoscale superconducting devices with application in quantum technologies. First, the article introduces the main superconducting devices and their fabrication by means of standard lithography techniques such as optical lithography and electron beam lithography. Then, focused ion beam patterning of superconductors through milling or irradiation is shown, as well as the growth of superconducting devices by means of focused electron and ion beam induced deposition. We suggest that the key benefits of these resist-free direct-growth techniques for quantum technologies include the ability to make electrical nanocontacts and circuit edit, fabrication of high-resolution superconducting resonators, creation of Josephson junctions and superconducting quantum interference device (SQUIDs) for on-tip sensors, patterning of high-Tc SQUIDs and other superconducting circuits, and the exploration of fluxtronics and topological superconductivity.