Pasar al contenido principal

CONFIGURACION Y OPTIMIZACION AUTONOMAS DE REDES DE SEGURIDAD PUBLICA BASADAS EN LTE

RTI2018-099063-B-I00

•
Nombre agencia financiadora Agencia Estatal de Investigación
Acrónimo agencia financiadora AEI
Programa Programa Estatal de I+D+i Orientado a los Retos de la Sociedad
Convocatoria Proyectos I+D+i Retos de Investigación
Año convocatoria 2018
Plan Estatal 2017-2020 Plan Estatal de Investigación Científica y Técnica y de Innovación
Centro beneficiario UNIVERSIDAD DE ZARAGOZA

Resultados relacionados

Resultados totales (Incluyendo duplicados): 5
Encontrada(s) 1 página(s)

UPCommons. Portal del coneixement obert de la UPC
Publicación Artículo científico (JournalArticle)

BMADS: BLE mesh asynchronous dynamic scanning

  • Pérez Díaz de Cerio, David|||0000-0003-0735-6811
  • Valenzuela González, José Luis|||0000-0002-7238-2621
  • García Lozano, Mario|||0000-0001-8155-9698
  • Hernandez Solana, Angela
  • Valdovinos, Antonio
© 2020 IEEE. Personal use of this material is permitted. Permission from IEEE must be obtained for all other uses, in any current or future media, including reprinting/republishing this material for advertising or promotional purposes, creating new collective works, for resale or redistribution to servers or lists, or reuse of any copyrighted component of this work in other works., The Bluetooth low-energy (BLE) mesh profile, currently standardized by the Bluetooth Special Interest Group (SIG), assumes that friend and relay nodes should be continuously scanning the channel ready to receive any incoming transmissions (TXs). This is very inefficient in terms of energy consumption. Hence, we present BMADS, an asynchronous dynamic scanning mechanism designed to reduce the overall energy consumption of the mesh network. BMADS is implemented as a new feature for the currently published BLE mesh specifications without modifying its core. This feature reduces the scanning cycles of the nodes, but still ensuring the reliability. To make this possible, BMADS sends a new control message sequence before transmitting the data. This sequence puts the nodes into continuous scan mode, preparing the network for data TX. The proposal can be used in BLE sensor networks that can tolerate a certain TX delay and require especially low-energy consumption. BMADS allows a theoretical reduction in the energy consumption of the relay nodes up to 98%., This work has been funded by the Spanish Ministry of Science through the projects RTI2018-099880-B-C32, RTI2018-095684-B-I00, RTI2018-099063-B-I00 with ERFD funds and by the Government of Aragon (Reference Group T31 20R), Peer Reviewed
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Experimental Evaluation of Transmitted Signal Distortion Caused by Power Allocation in Inter-Cell Interference Coordination Techniques for LTE/LTE-A and 5G Systems

  • Hernandez-Solana, A.
  • García-Dúcar, P.
  • Valdovinos, A.
  • Garcia, J. E.
  • De Mingo, J.
  • Carro, P. L.
Error vector magnitude (EVM) and out-of-band emissions are key metrics for evaluating in-band and out-band distortions introduced by all potential non-idealities in the transmitters of wireless systems. As EVM is a measure of the quality of the modulated signal/symbols, LTE/LTE-A and 5G systems specify mandatory EVM requirements in transmission for each modulation scheme. This paper analyzes the influence of the mandatory satisfaction of EVM requirements on the design of radio resource management strategies (RRM) (link adaptation, inter-cell interference coordination), specifically in the downlink (DL). EVM depends on the non-idealities of the transmitter implementations, on the allocated power variations between the subcarriers and on the selected modulations. In the DL of LTE, link adaptation is usually executed by adaptive modulation and coding (AMC) instead of power control, but some flexibility in power allocation remains being used. LTE specifies some limits in the power dynamic ranges depending on the allocated modulation, which ensures the satisfaction of EVM requirements. However, the required recommendations concerning the allowed power dynamic range when inter-cell interference coordination (ICIC) and enhanced ICIC (eICIC) mechanisms (through power coordination) are out of specification, even though the EVM performance should be known to obtain the maximum benefit of these strategies. We perform an experimental characterization of the EVM in the DL under real and widely known ICIC implementation schemes. These studies demonstrate that an accurate analysis of EVM is required. It allows a better adjustment of the design parameters of these strategies, and also allows the redefinition of the main criteria to be considered in the implementation of the scheduler/link adaptation concerning the allocable modulation coding scheme (MCS) in each resource block. © 2013 IEEE.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

On the use of sniffers for spectrum occupancy measurements of Bluetooth low energy primary channels

  • Valenzuela-Pérez, A.
  • García-Lozano, M.
  • Valenzuela, J. L.
  • Pérez-Díaz-de-Cerio, D.
  • Hernández Solana, Á.
  • Valdovinos, A.
The methods usually employed to measure channel occupancy show limitations in the context of Bluetooth Low Energy (BLE) advertisements. We propose and analyze the use of BLE sniffers as light and portable low-cost spectrum occupancy meters to be used in scenarios where real time signal analyzers are not adequate. For the measurement technique to be successful, several low-level effects must be considered. The paper argues about on-air time, receiving blind times due to processing and intra system interference, buffer saturation and frequency anchoring. Hence, a compensation procedure based on collision rate estimation is proposed. Results with the refined method show that occupancies of 40% can be measured with an overestimation error whose percentile 95% is 5 percentage points. This is reduced to 1.9 points when the occupancy is 15%. The sniffers perform in real time and are shown to correctly track short term load variations. The strategy has been successfully used to characterize occupancy in highly variable and loaded scenarios such as subway platforms and a shopping mall. Values up to 25% have been observed, which implies a relevant packet error rate. Hence, the tool can be used to make agile audits and configure the parameters that control communication redundancy in new or existing networks.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

Analysis of Scaling Policies for NFV Providing 5G/6G Reliability Levels With Fallible Servers

  • Ortin, Jorge
  • Serrano, Pablo
  • Garcia-Reinoso, Jaime
  • Banchs, Albert
The softwarization of mobile networks enables an efficient use of resources, by dynamically scaling and re-assigning them following variations in demand. Given that the activation of additional servers is not immediate, scaling up resources should anticipate traffic demands to prevent service disruption. At the same time, the activation of more servers than strictly necessary results in a waste of resources, and thus should be avoided. Given the stringent reliability requirements of 5G applications (up to 6 nines) and the fallible nature of servers, finding the right trade-off between efficiency and service disruption is particularly critical. In this paper, we analyze a generic auto-scaling mechanism for communication services, used to de(activate) servers in a cluster, based on occupation thresholds. We model the impact of the activation delay and the finite lifetime of the servers on performance, in terms of power consumption and failure probability. Based on this model, we derive an algorithm to optimally configure the thresholds. Simulation results confirm the accuracy of the model both under synthetic and realistic traffic patterns as well as the effectiveness of the configuration algorithm. We also provide some insights on the best strategy to support an energy-efficient highly-reliable service: deploying a few powerful and reliable machines versus deploying many machines, but less powerful and reliable.
Recercat. Dipósit de la Recerca de Catalunya
Publicación Artículo científico (JournalArticle)

BMADS: BLE mesh asynchronous dynamic scanning

  • Pérez Díaz de Cerio, David
  • Valenzuela González, José Luis
  • García Lozano, Mario
  • Hernandez Solana, Angela
  • Valdovinos, Antonio
© 2020 IEEE. Personal use of this material is permitted. Permission from IEEE must be obtained for all other uses, in any current or future media, including reprinting/republishing this material for advertising or promotional purposes, creating new collective works, for resale or redistribution to servers or lists, or reuse of any copyrighted component of this work in other works., The Bluetooth low-energy (BLE) mesh profile, currently standardized by the Bluetooth Special Interest Group (SIG), assumes that friend and relay nodes should be continuously scanning the channel ready to receive any incoming transmissions (TXs). This is very inefficient in terms of energy consumption. Hence, we present BMADS, an asynchronous dynamic scanning mechanism designed to reduce the overall energy consumption of the mesh network. BMADS is implemented as a new feature for the currently published BLE mesh specifications without modifying its core. This feature reduces the scanning cycles of the nodes, but still ensuring the reliability. To make this possible, BMADS sends a new control message sequence before transmitting the data. This sequence puts the nodes into continuous scan mode, preparing the network for data TX. The proposal can be used in BLE sensor networks that can tolerate a certain TX delay and require especially low-energy consumption. BMADS allows a theoretical reduction in the energy consumption of the relay nodes up to 98%., This work has been funded by the Spanish Ministry of Science through the projects RTI2018-099880-B-C32, RTI2018-095684-B-I00, RTI2018-099063-B-I00 with ERFD funds and by the Government of Aragon (Reference Group T31 20R), Peer Reviewed, Postprint (author's final draft)