Skip to main content

ESTUDIO DE INTERFACES EN CAPAS DE PEROVSKITA DE ALTO RENDIMIENTO FOTOVOLTAICO

MAT2016-76892-C3-2-R

•
Funding agency name Agencia Estatal de Investigación
Funding agency acronym AEI
Program Programa Estatal de I+D+i Orientado a los Retos de la Sociedad
Call Proyectos I+D+i Retos de Investigación
Call year 2016
State Plan 2013-2016 Plan Estatal de Investigación Científica y Técnica y de Innovación
Beneficiary centre UNIVERSIDAD PABLO DE OLAVIDE, DE SEVILLA

Resultados relacionados

Resultados totales (Incluyendo duplicados): 3
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

Impact of moisture on efficiency-determining electronic processes in perovskite solar cells

  • Salado, Manuel
  • Contreras-Bernal, Lidia
  • Calió, Laura
  • Todinova, Anna
  • López-Santos, Carmen
  • Ahmad, Shahzada
  • Borrás, Ana
  • Idígoras, Jesús
  • Anta, Juan A.
Moisture-induced degradation in perovskite solar cells was thoroughly investigated by structural (SEM, EDS, XRD and XPS) and device characterization (impedance and intensity modulated photocurrent spectroscopy) techniques. Both the influence of the perovskite composition and the nature of the hole selective material were analyzed. The degradation rate was found to be significantly slower for mixed perovskites and P3HT-based devices. However, for a fixed degradation degree (defined as a 50% drop from the initial photocurrent), all configurations show similar features in small-perturbation analysis. Thus, a new mid-frequency signal appears in the impedance response, which seems to be related to charge accumulation at the interfaces. In addition, faster recombination, with a more important surface contribution, and slower transport were clearly inferred from our results. Both features can be associated with the deterioration of the contacts and the formation of a higher number of grain boundaries., We thank Junta de Andalucía for financial support via grant FQM 1851 and FQM 2310. We thank the Ministerio de Economía y Competitividad of Spain (MAT2013-47192-C3-3-R and MAT2016-76892-C3-2-R) and the EU through the Cohesion Fund and FEDER programs (MAT2013-42900-P and MAT2016-79866-R) for financial support and Red de Excelencia “Emerging photovoltaic Technologies”. SA and LC are thankful for the “Thinface” project from the European Union Seventh Framework Programme, under grant agreement no. 607232, for financial support., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

The role of surface recombination on the performance of perovskite solar cells: effect of morphology and crystalline phase of TiO2 contact

  • Idígoras, Jesús
  • Contreras-Bernal, Lidia
  • Cave, James M.
  • Courtier, Nicola E.
  • Barranco, Ángel
  • Borrás, Ana
  • Sánchez-Valencia, J. R.
  • Anta, Juan A.
  • Walker, Alison B.
Herein, the preparation of 1D TiO nanocolumnar films grown by plasma-enhanced chemical vapor deposition is reported as the electron selective layer (ESL) for perovskite solar devices. The impact of the ESL architecture (1D and 3D morphologies) and the nanocrystalline phase (anatase and amorphous) is analyzed. For anatase structures, similar power conversion efficiencies are achieved using an ESL either the 1D nanocolumns or the classical 3D nanoparticle film. However, lower power conversion efficiencies and different optoelectronic properties are found for perovskite devices based on amorphous 1D films. The use of amorphous TiO as electron selective contact produces a bump in the reverse scan of the current–voltage curve as well as an additional electronic signal, detected by impedance spectroscopy measurements. The dependence of this additional signal on the optical excitation wavelength used in the IS experiments suggests that it stems from an interfacial process. Calculations using a drift-diffusion model which explicitly considers the selective contacts reproduces qualitatively the main features observed experimentally. These results demonstrate that for a solar cell in which the contact is working properly the open-circuit photovoltage is mainly determined by bulk recombination, whereas the introduction of a “bad contact” shifts the balance to surface recombination., The authors thank Junta de Andalucía for financial support via grant FQM 1851 and FQM 2310. The authors thank Ministerio de Economía y Competitividad of Spain and Agencia Estatal de Investigación (AEI) and EU (FEDER) under grants MAT2013‐47192‐C3‐3‐R, MAT2016‐76892‐C3‐2‐R, MAT2016‐79866‐R and Red de Excelencia “Emerging photovoltaic Technologies” for financial support. J.R.S.‐V. and A.B. acknowledge Marie Skłodowska‐Curie ActionsH2020‐MSCA‐IF‐2014 PlasmaPerovSol grant (Project ID 661480) and the University of Seville through the VI PPIT‐US. J.M.C. and N.E.C. were supported by EPSRC funded studentships from the CDT in New and Sustainable Photovoltaics (reference EP/L01551X/1). A.B.W. was supported by the Energy oriented Centre of Excellence (EoCoE), Horizon2020 grant research number 676629.
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

Enhanced stability of perovskite solar cells incorporating dopant-free Crystalline spiro-OMeTAD layers by vacuum sublimation

  • Barranco, Ángel
  • López-Santos, Carmen
  • Idígoras, Jesús
  • Aparicio, Francisco J.
  • Obrero-Pérez, José M.
  • López-Flores, Víctor
  • Contreras-Bernal, Lidia
  • Rico, Víctor J.
  • Ferrer, F. J.
  • Espinós, J.P.
  • Borrás, Ana
  • Anta, Juan A.
  • Sánchez-Valencia, J. R.
The main handicap still hindering the eventual exploitation of organometal halide perovskite-based solar cells is their poor stability under prolonged illumination, ambient conditions, and increased temperatures. This article shows for the first time the vacuum processing of the most widely used solid-state hole conductor (SSHC), i.e., the Spiro-OMeTAD [2,2′,7,7′-tetrakis (N,N-di-p-methoxyphenyl-amine) 9,9′-spirobifluorene], and how its dopant-free crystalline formation unprecedently improves perovskite solar cell (PSC) stability under continuous illumination by about two orders of magnitude with respect to the solution-processed reference and after annealing in air up to 200 °C. It is demonstrated that the control over the temperature of the samples during the vacuum deposition enhances the crystallinity of the SSHC, obtaining a preferential orientation along the π–π stacking direction. These results may represent a milestone toward the full vacuum processing of hybrid organic halide PSCs as well as light-emitting diodes, with promising impacts on the development of durable devices. The microstructure, purity, and crystallinity of the vacuum sublimated Spiro-OMeTAD layers are fully elucidated by applying an unparalleled set of complementary characterization techniques, including scanning electron microscopy, X-ray diffraction, grazing-incidence small-angle X-ray scattering and grazing-incidence wide-angle X-ray scattering, X-ray photoelectron spectroscopy, and Rutherford backscattering spectroscopy., The authors thank the “Agencia Estatal de Investigación”, “Consejería de Economía y Conocimiento de la Junta de Andalucía” (US‐1263142), “Ministerio de Economía y Competitividad” (MAT2016‐79866‐R, MAT2013‐42900‐P, FPA2016‐77689‐C2‐1‐R, and MAT2016‐76892‐C3‐2‐R) and the European Union (EU) through cohesion fund and FEDER 2014‐2020 programs for financial support. J.R.S.‐V. and A.B. acknowledge the EU project PlasmaPerovSol and funding from the European Union's Horizon 2020 research and innovation programme under the Marie Skłodowska‐Curie grant agreement ID 661480. J.R.S.‐V‐ and M.C.L.‐S. thank the University of Seville through the VI “Plan Propio de Investigación y Transferencia de la US” (VI PPIT‐US). This research has received funding from the EU‐H2020 research and innovation programme under Grant Agreement No. 654360 having benefitted from the access provided by Technische Universität Graz at Elettra—TUG in Trieste (IT) within the framework on the NFFA (Nanoscience Foundries & Fine Analysis) Europe Transnational Access Activity. F.J.A. and J.R.S.‐V. acknowledge the “Juan de la Cierva” and “Ramon y Cajal” national programs, respectively.