Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 5
Encontrada(s) 1 página(s)

RUC. Repositorio da Universidade da Coruña
Publicación Artículo científico (JournalArticle)

On The Thermal Conductivity of Conjugated Polymers for Thermoelectrics

  • Rodríguez-Martínez, Xabier
  • Martín, Jaime
  • Campoy-Quiles, Mariano
[Abstract]: The thermal conductivity (κ) governs how heat propagates in a material, and thus is a key parameter that constrains the lifetime of optoelectronic devices and the performance of thermoelectrics (TEs). In organic electronics, understanding what determines κ has been elusive and experimentally challenging. Here, by measuring κ in 17 π-conjugated materials over different spatial directions, it is statistically shown how microstructure unlocks two markedly different thermal transport regimes. κ in long-range ordered polymers follows standard thermal transport theories: improved ordering implies higher κ and increased anisotropy. κ increases with stiffer backbones, higher molecular weights and heavier repeat units. Therein, charge and thermal transport go hand-in-hand and can be decoupled solely via the film texture, as supported by molecular dynamics simulations. In largely amorphous polymers, however, κ correlates negatively with the persistence length and the mass of the repeat unit, and thus an anomalous, albeit useful, behavior is found. Importantly, it is shown that for quasi-amorphous co-polymers (e.g., IDT-BT) κ decreases with increasing charge mobility, yielding a 10-fold enhancement of the TE figure-of-merit ZT compared to semi-crystalline counterparts (under comparable electrical conductivities). Finally, specific material design rules for high and low κ in organic semiconductors are provided., The authors would like to acknowledge financial support from the Spanish Ministry of Science and Innovation through the “Severo Ochoa” Programme for Centers of Excellence in R&D and project reference PID2021- 128924OB-I00 as well acknowledge Prof. Alejandro R. Goñi (ICMAB-CSIC, ICREA) for his valuable help in setting up the Raman thermometry measurement platform. The authors are thankful to Dr. Aleksandr Perevedentsev (ICMAB-CSIC) for his know-how regarding the fabrication of free-standing films, as well as for the preparation of the drop cast DH6T films. The authors are very thankful to Prof. Paul Smith (ETH Zürich) for fruitful discussions about polymer processing and Prof. Christian Müller for his useful comments on this work, and the suggestions regarding thermal diffusivity. The authors also thank Andrés Gómez for performing the nanoindentation experiments. I.M. and H.C. acknowledge King Abdullah University of Science and Technology Office of Sponsored Research (OSR) under awards no. OSR-2018-CARF/CCF-3079, and OSR-4106 CPF2019 as well as EC FP7 Project SC2 (610115).as the European Research Council (ERC) under grant agreement no. 648901. This work was financially supported by the European Commission through the Marie Skłodowska-Curie projects HORATES (GA-955837). J.M. is also grateful to the Spanish Ministry of Science and Innovation through project PGC2018-094620-A-I00. The authors also acknowledge the support from the Marie Skłodowska-Curie program (action no. 793726 – TELIOTES) and the Centro de Supercomputación de Galicia (CESGA) for the use of their computational resources. The authors, Arabia Saudita. King Abdullah University of Science and Technology; OSR-2018-CARF/CCF-3079, Arabia Saudita. King Abdullah University of Science and Technology; OSR-4106 CPF2019
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Anisotropic Thermal Conductivity in Few-Layer and Bulk Titanium Trisulphide from First Principles

  • Saiz, Fernan
  • Carrete, Jesús
  • Rurali, Riccardo
© 2020 by the authors., We study the thermal conductivity of monolayer, bilayer, and bulk titanium trisulphide (TiS 3 ) by means of an iterative solution of the Boltzmann transport equation based on ab-initio force constants. Our results show that the thermal conductivity of these layers is anisotropic and highlight the importance of enforcing the fundamental symmetries in order to accurately describe the quadratic dispersion of the flexural phonon branch near the center of the Brillouin zone., This research received the financial support by the Ministerio de Economía, Industria y Competitividad (MINECO) under grant FEDER-MAT2017-90024-P and the Severo Ochoa Centres of Excellence Program under Grant SEV-2015-0496 and by the Generalitat de Catalunya under grants no. 2017 SGR 1506. The authors acknowledge the funding received from the European Union’s Horizon 2020 research and innovation programme under grant agreement No. 793726 (TELIOTES—Thermal and electronic transport in inorganic-organic thermoelectric superlattices)., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Optimisation of the thermoelectric efficiency of zirconium trisulphide monolayers through unixial and biaxial strain

  • Saiz, Fernan
  • Carrete, Jesús
  • Rurali, Riccardo
The goal of this work is to investigate the influence of mechanical deformation on the electronic and thermoelectric properties of ZrS3 monolayers. We employ density functional theory (DFT) calculations at the hybrid HSE06 level to evaluate the response of the electronic band gap and mobilities, as well as the thermopower, the electrical conductivity, the phononic and electronic contributions to the thermal conductivity, and the heat capacity. Direct examination of the electronic band structures reveals that the band gap can be increased by up to 17% under uniaxial strain, reaching a maximum value of 2.32 eV. We also detect large variations in the electrical conductivity, which is multiplied by 3.40 under a 4% compression, but much smaller changes in the Seebeck coefficient. The effects of mechanical deformation on thermal transport are even more significant, with a nearly five-fold reduction of the lattice thermal conductivity under a biaxial strain of −4%. By harnessing a combination of these effects, the thermoelectric figure of merit of strained ZrS3 could be doubled with respect to the unstrained material., We acknowledge the financial support received from the European Union's Horizon 2020 research and innovation programme under grant agreement No. 793726 (TELIOTES – Thermal and electronic transport in inorganic-organic thermoelectric superlattices), from the Ministerio de Economía, Industria y Competitividad (MINECO) under grant FEDER-MAT2017-90024-P and the Severo Ochoa Centres of Excellence Program Grant SEV-2015-0496, and from the Generalitat de Catalunya under grant no. 2017 SGR 1506. We also acknowledge the support from The Supercomputing Center of Galicia (CESGA), where the calculations have been made, and the fruitful discussions with Dr Andrés Castellanos-Gomez., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Interatomic potential for predicting the thermal conductivity of zirconium trisulfide monolayers with molecular dynamics

  • Saiz, Fernan
  • Karaaslan, Yenal
  • Rurali, Riccardo
  • Sevik, Cem
We present here a new interatomic potential parameter set to predict the thermal conductivity of zirconium trisulfide monolayers. The generated Tersoff-type force field is parameterized using data collected with first-principles calculations. We use non-equilibrium molecular dynamics simulations to predict the thermal conductivity. The generated parameters result in very good agreement in structural, mechanical, and dynamical parameters. The room temperature lattice thermal conductivity (κ) of the considered crystal is predicted to be κxx = 25.69 W m−1 K−1 and κyy = 42.38 W m−1 K−1, which both agree well with their corresponding first-principles values with a discrepancy of less than 5%. Moreover, the calculated κ variation with temperature (200 and 400 K) are comparable within the framework of the accuracy of both first-principles and molecular dynamics simulations, We acknowledge the financial support received from the European Union’s Horizon 2020 Research and Innovation Program under Grant Agreement No. 793726 (TELIOTES—Thermal and electronic transport in inorganic–organic thermoelectric superlattices) and the support of the Supercomputing Center of Galicia (CESGA), where the calculations have been made. We also acknowledge financial support by the Ministerio de Economía, Industria y Competitividad (MINECO) under Grant No. FEDER-MAT2017-90024-P, the Severo Ochoa Centres of Excellence Program under Grant No. SEV-2015-0496, and the Generalitat de Catalunya under Grant No. 2017 SGR 1506. The authors acknowledge the fruitful discussions with Dr. Jesús Carrete Montaña at TU Wien., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

On The Thermal Conductivity of Conjugated Polymers for Thermoelectrics

  • Rodríguez Martínez, Xabier
  • Saiz, Fernan
  • Dörling, Bernhard
  • Marina, Sara
  • Guo, Jiali
  • Xu, Kai
  • Chen, Hu
  • Martin, Jaime
  • McCulloch, Iain
  • Rurali, Riccardo
  • Reparaz, J. Sebastian
  • Campoy Quiles, Mariano
The thermal conductivity (κ) governs how heat propagates in a material, and thus is a key parameter that constrains the lifetime of optoelectronic devices and the performance of thermoelectrics (TEs). In organic electronics, understanding what determines κ has been elusive and experimentally challenging. Here, by measuring κ in 17 π-conjugated materials over different spatial directions, it is statistically shown how microstructure unlocks two markedly different thermal transport regimes. κ in long-range ordered polymers follows standard thermal transport theories: improved ordering implies higher κ and increased anisotropy. κ increases with stiffer backbones, higher molecular weights and heavier repeat units. Therein, charge and thermal transport go hand-in-hand and can be decoupled solely via the film texture, as supported by molecular dynamics simulations. In largely amorphous polymers, however, κ correlates negatively with the persistence length and the mass of the repeat unit, and thus an anomalous, albeit useful, behavior is found. Importantly, it is shown that for quasi-amorphous co-polymers (e.g., IDT-BT) κ decreases with increasing charge mobility, yielding a 10-fold enhancement of the TE figure-of-merit ZT compared to semi-crystalline counterparts (under comparable electrical conductivities). Finally, specific material design rules for high and low κ in organic semiconductors are provided., The authors would like to acknowledge financial support from the Spanish Ministry of Science and Innovation through the “Severo Ochoa” Programme for Centers of Excellence in R&D and project reference PID2021-128924OB-I00 as well as the European Research Council (ERC) under grant agreement no. 648901. This work was financially supported by the European Commission through the Marie Skłodowska-Curie projects HORATES (GA-955837). J.M. is also grateful to the Spanish Ministry of Science and Innovation through project PGC2018-094620-A-I00. The authors also acknowledge the support from the Marie Skłodowska-Curie program (action no. 793726 – TELIOTES) and the Centro de Supercomputación de Galicia (CESGA) for the use of their computational resources. The authors acknowledge Prof. Alejandro R. Goñi (ICMAB-CSIC, ICREA) for his valuable help in setting up the Raman thermometry measurement platform. The authors are thankful to Dr. Aleksandr Perevedentsev (ICMAB-CSIC) for his know-how regarding the fabrication of free-standing films, as well as for the preparation of the drop cast DH6T films. The authors are very thankful to Prof. Paul Smith (ETH Zürich) for fruitful discussions about polymer processing and Prof. Christian Müller for his useful comments on this work, and the suggestions regarding thermal diffusivity. The authors also thank Andrés Gómez for performing the nanoindentation experiments. I.M. and H.C. acknowledge King Abdullah University of Science and Technology Office of Sponsored Research (OSR) under awards no. OSR-2018-CARF/CCF-3079, and OSR-4106 CPF2019 as well as EC FP7 Project SC2 (610115)., With funding from the Spanish government through the ‘Severo Ochoa Centre of Excellence’ accreditation (CEX2019-000917-S)., Peer reviewed