Skip to main content

Resultados relacionados

Resultados totales (Incluyendo duplicados): 5
Encontrada(s) 1 página(s)

DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Artículo científico (JournalArticle)

Controlling the surface chemistry of graphene oxide: Key towards efficient ZnO-GO photocatalysts

  • Víctor-Román, Sandra
  • García-Bordejé, José Enrique
  • Hernández-Ferrer, Javier
  • González Domínguez, José Miguel
  • Ansón-Casaos, Alejandro
  • Silva, Adrián M. T.
  • Maser, Wolfgang K.
  • Benito, Ana M.
12 Figures, 3 Tables.-- © 2019. This manuscript version is made available under the CC-BY-NC-ND 4.0 license http://creativecommons.org/licenses/by-nc-nd/4.0/, Graphene oxide (GO) and related materials are widely reported to enhance the photocatalytic activity of zinc oxide. However, the origin of the observed performance improvements remains elusive and studies contributing to a deeper understanding of this critical issue are largely missing. In this work, we have prepared a set of benchmark ZnO-GO hybrid materials in order to systematically put under closer scrutiny the influence of the surface chemistry of GO on the photocatalytic degradation of methylene blue. The set of ZnO-GO hybrids has been synthesized in an ultrasonication process involving ZnO nanoparticles obtained in a microwave synthesis process and GO with three distinct oxidation degrees, employed in three different loading fractions. Structural and physical-chemical characterization by XRD, FTIR, Raman, UV–vis, photoluminescence and spectroscopy and XPS, consistently demonstrate the importance of the surface chemistry of GO for establishing photo-induced charge-transfer interface interactions with ZnO, facilitating the enhancement of the catalytic activity of the ZnO-GO catalyst. Optimized interface interactions thus enabled the design of a ZnO-GO catalyst exhibiting a conversion rate of 80% obtained in a time of 70 min and at a catalyst concentration of only 0.045 mg/mL., This work was financially supported by the Spanish MINEICO (project grant ENE 2016-79282-C5-1-R), Gobierno de Aragón (Grupo Reconocido DGA T03_17R), and associated EU Regional Development Funds. This work has been also partially supported by Project POCI-01-0145-FEDER-006984 – Associate Laboratory LSRE-LCM funded by European Regional Development Fund (ERDF) through COMPETE2020-Programa Operacional Competitividade e Internacionalização (POCI) – and by national funds through FCT-Fundação para a Ciência e a Tecnologia. S. Víctor-Roman acknowledges Spanish MINEICO for her PhD grant (BES2014-068727 and associated EU Social Funds) and for her research stay scholarship in Portugal (EEBB-I-18-12785). J.M. González-Domínguez acknowledges Spanish Ministry of Science, Innovation and Universities for his 'Juan de la Cierva - Incorporación' grant (IJCI-2016-27789)., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publication Contribución de congreso (ConferenceOutput)

The surface chemistry of graphene oxide: Key towards enhanced performance of ZnO-GO photocatalysts

  • Víctor-Román, Sandra
  • García-Bordejé, José Enrique
  • Hernández-Ferrer, Javier
  • González Domínguez, José Miguel
  • Ansón-Casaos, Alejandro
  • Silva, Adrián M. T.
  • Maser, Wolfgang K.
  • Benito, Ana M.
2 figures.-- Abstract ot the poster presented at the NanoteC19 conference, International Conference on Carbon Nanosciene and Nanotechnology, 27th-30th august 2019, Zaragoza (Spain)., Graphene oxide (GO) is known to facilitate the enhancement of the photocatalytic performance of semiconducting metal oxides such as TiO2 or ZnO. However, the influence of its particular surface chemistry has not been clarified. In this work we employ GO with distinct and well-defined oxidation degree for the preparation of ZnO-GO hybrid materials. We demonstrate that the surface chemistry of GO is key for facilitating favorable interface interactions. This results in a lowering of the alignment of energy levels at the ZnO-GO interface and enables the transfer of photo-excited electrons from ZnO to GO. The remaining positive charge at the valence band of ZnO then easily can promote oxidation reactions with the analyte and/or the solvent. In this way, GO reduces the recombination rate of the photogenerated electron-hole pair and enhances the photocatalytic activity of ZnO. We show that by solely controlling the oxidation degree of GO and by optimizing the loading fraction highly efficient ZnO-GO photocatalysts can be prepared. Most favorable conditions are achieved for intermediate oxidation degrees of GO. Optimized ZnO-GO hybrids thus reveal photocatalytic degradation of methylene blue at conversion rates of up to 80%, within times as short as 70 minutes at concentrations as low as 0.045 mg/mL, accompanied by a good recyclability behavior. The results are of general character and extendable to semiconducting metal oxides used in photocatalysis [1]., Spanish MINEICO (Project ENE2016-79282-C5-1-R, AEI/FEDER, UE and FPI Grant BES2014-068727) and Government of Aragon (DGA-T03-17R, FEDER, UE), is gratefully acknowledged., Peer reviewed
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publication Artículo científico (JournalArticle)

Photoactivity improvement of TiO2 electrodes by thin hole transport layers of reduced graphene oxide

  • Hernández-Ferrer, J.
  • Ansón-Casaos, A.
  • Víctor-Román, S.
  • Sanahuja-Parejo, O.
  • Martínez, M.T.
  • Villacampa, B.
  • Benito, A.M.
  • Maser, W.K.
Nanostructured TiO2 and graphene-based materials constitute components of actual interest in devices related to solar energy conversion and storage. In this work, we show that a thin layer of electrochemically reduced graphene oxide (ECrGO), covering nanostructured TiO2 photoelectrodes, can significantly improve the photoactivity. In order to understand the working principle, ECrGO/TiO2 photoelectrodes with different ECrGO thicknesses were prepared and studied by a set of photoelectrochemical measurements. Methanol in alkaline conditions was employed as effective hole acceptor probe to elucidate the electronic phenomena in the electrode layers and interfaces. These studies underline the hole accepting properties of ECrGO and reveal the formation of a p-n junction at the interface between ECrGO and TiO2. It is shown for the first time that the resulting space charge region of about 10 nm defines the operational functionality of the ECrGO layer. Films thinner than the space charge region act as hole transport layer (HTL), which efficiently transfers holes to the liquid interface thus leading to enhanced photoactivity. Thicker films however act as hole blocking layer (HBL), resulting in a systematic decrease of the photoactivity. The finding of a thickness dependent threshold value for the operation of ECrGO as HTL and HBL is of general interest for the fabrication of optoelectronic devices with improved performance.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publication Artículo científico (JournalArticle)

Percolating Metallic Structures Templated on Laser-Deposited Carbon Nanofoams Derived from Graphene Oxide: Applications in Humidity Sensing

  • Nufer, Sebastian
  • Fantanas, Dimitrios
  • Ogilvie, Sean P.
  • Large, Matthew J.
  • Winterauer, Dominik J.
  • Salvage, Jonathan P.
  • Meloni, Manuela
  • King, Alice A. K.
  • Schellenberger, Pascale
  • Shmeliov, Aleksey
  • Victor-Roman, Sandra
  • Pelaez-Fernandez, Mario
  • Nicolosi, Valeria
  • Arenal, Raul
  • Benito, Ana M.
  • Maser, Wolfgang
  • Brunton, Adam
  • Dalton, Alan B.
Carbon nanofoam (CNF) is a low-density, high-surface-area material formed by aggregation of amorphous carbon nanoparticles into porous nanostructures. We report the use of a pulsed infrared laser to prepare CNF from a graphene oxide (GO) target material. Electron microscopy shows that the films consist of dendritic strings that form web-like three-dimensional structures. The conductivity of these structures can be modified by using the CNF as a nanostructured scaffold for gold nanoparticles deposited by sputter coating, controllably increasing the conductivity by up to 4 orders of magnitude. The ability to measure the conductivity of the porous structures allows electrochemical measurements in the environment. Upon decreasing humidity, the pristine CNF exhibits an increase in resistance with a quick response and recovery time. By contrast, the gold-sputtered CNF showed a decrease in resistance, indicating modification of the doping mechanism due to water adsorption. The sensitivity to humidity is eliminated at the percolation threshold of the metal on the CNF.
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publication Artículo científico (JournalArticle)

The viscosity of dilute carbon nanotube (1D) and graphene oxide (2D) nanofluids

  • Ansón-Casaos, A.
  • Ciria, J.C.
  • Sanahuja-Parejo, O.
  • Víctor-Román, Sandra
  • González-Domínguez, J.M.
  • García-Bordejé, E.
  • Benito, Ana M.
  • Maser, W.K.
Controlling the physicochemical properties of nanoparticles in fluids directly impacts on their liquid phase processing and applications in nanofluidics, thermal engineering, biomedicine and printed electronics. In this work, the temperature dependent viscosity of various aqueous nanofluids containing carbon nanotubes (CNTs) or graphene oxide (GO), i.e. 1D and 2D nanoparticles with extreme aspect ratios, is analyzed by empirical and predictive physical models. The focus is to understand how the nanoparticle shape, concentration, motion degrees and surface chemistry affect the viscosity of diluted dispersions. To this end, experimental results from capillary viscosimeters are first examined in terms of the energy of viscous flow and the maximum packing fraction applying the Maron–Pierce model. Next, a comparison of the experimental data with predictive physical models is carried out in terms of nanoparticle characteristics that affect the viscosity of the fluid, mostly their aspect ratio. The analysis of intrinsic viscosity data leads to a general understanding of motion modes for carbon nanoparticles, including those with extreme aspect ratios, in a flowing liquid. The resulting universal curve might be extended to the prediction of the viscosity for any kind of 1D and 2D nanoparticles in dilute suspensions.