Pasar al contenido principal

MEJORA CATALITICA DE LOS BIOCOMBUSTIBLES PRODUCIDOS POR PIROLISIS DE BIOMASA LIGNOCELULOSICA

CTQ2012-37984-C02-01

•
Nombre agencia financiadora Ministerio de Economía y Competitividad
Acrónimo agencia financiadora MINECO
Programa Programa Nacional de Proyectos de Investigación Fundamental
Subprograma Subprograma de Proyectos de Investigación Fundamental no Orientada
Convocatoria Proyectos I+D
Año convocatoria 2012
Plan Estatal 2008-2011 Plan Nacional de Investigación Científica, Desarrollo e Innovación Tecnológica
Unidad de gestión Secretaría de Estado de Investigación, Desarrollo e Innovación
Centro beneficiario AGENCIA ESTATAL CONSEJO SUPERIOR DE INVESTIGACIONES CIENTIFICAS (CSIC)
Identificador persistente http://dx.doi.org/10.13039/501100003329

Resultados relacionados

Resultados totales (Incluyendo duplicados): 7
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Porous clays heterostructures as supports of iron oxide for environmental catalysis

  • Sanchis Martinez, Rut
  • Cecilia,J.A.
  • Vazquez, Isabel
  • Dejoz, Ana
  • Rodriguez-Castellon, E.
  • Solsona Espriu, Benjamin Eduardo
  • Soriano Rodríguez, Mª Dolores|||0000-0002-1799-895X
  • López Nieto, José Manuel|||0000-0002-6960-3219
[EN] Porous Clays Heterostructures (PCH) from natural pillared clays (bentonite with a high proportion of montmorillonite) have been used as supports of iron oxide for two reactions of environmental interest: i) the elimination of toluene (a representative compound of one of the most toxic subsets of volatile organic compounds, aromatics) by total oxidation and ii) the selective oxidation of H2S to elemental sulfur. For both reactions these catalysts have resulted to be remarkably more efficient than similar catalysts prepared using conventional silica as a support. Thus, in the total oxidation of toluene it has been observed that the catalytic activity obtained using siliceous PCH is two orders of magnitude higher than that with conventional silica. The catalytic activity has shown to be dependant of the capacity of the support for dispersing iron oxide in a way that the higher the dispersion of iron oxide on the surface of the support, the higher is the activity. In the case of the selective oxidation of H2S to S both higher catalytic activity and higher selectivity to S have been observed using siliceous porous clays heterostructures than using conventional silica. Highly dispersed FeOx species have been shown as highly selective towards elemental sulfur whereas more aggregated FeOx species favour the formation of sulphur oxides decreasing the selectivity to S. Analyses of the surface by XPS have shown the predominance of sulfate species in the catalysts presenting low selectivity to elemental sulfur., The authors would like to acknowledge the DGICYT in Spain (CTQ2015-68951-C3-1-R, CTQ2015-68951-C3-3-R, CTQ2012-37925-C03-2, CTQ2012-37925-C03-3 and CTQ2012-37984-C02-01) and FEDER for financial support. We also thank the University of Valencia for funding (UV-INV-AE-16-484416) and SCSIE-UV for assistance.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Total oxidation of VOCs on mesoporous iron oxide catalysts: soft chemistry route versus hard template method

  • Solsona Espriu, Benjamin Eduardo
  • Garcia, T.
  • Sanchis Martinez, Rut
  • Moreno, M.
  • Rodríguez-Castellon, Enrique
  • Agouram, Said
  • Dejoz, Ana
  • Soriano Rodríguez, Mª Dolores|||0000-0002-1799-895X
  • López Nieto, José Manuel|||0000-0002-6960-3219
[EN] A comparative study on the total oxidation of volatile organic compounds, VOCs, on mesoporous iron oxide catalysts prepared by soft chemistry route versus those achieved by hard template method, The authors would like to acknowledge the DGICYT in Spain (CTQ2012-37925-C03-1, CTQ2012-37925-C03-2, CTQ2012-37925-C03-3 and CTQ2012-37984-C02-01) and FEDER for financial support. We also thank the University of Valencia and SCSIE-UV for assistance.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Insights into the catalytic production of hydrogen from propane in the presence of oxygen: cooperative presence of vanadium and gold catalysts

  • Garcia, T.
  • Lopez, J. M.
  • Dejoz, A.
  • Vazquez, M. I.
  • Solsona, B.
  • López Nieto, José Manuel|||0000-0002-6960-3219
  • Sanchis, R.|||0000-0002-5495-3339
[EN] H-2 and propylene can be obtained from propane and oxygen in defect using appropriate catalysts. Meanwhile propylene is formed from propane via oxidative or non-oxidative dehydrogenation, molecular hydrogen can be obtained from several reactions such as propane dehydrogenation, coke formation and water gas shift. It has been observed that a gold catalyst hardly activates propane and no H-2 was detected, whereas using vanadium oxide a relatively high concentration of propylene and H-2 was obtained. Interestingly, the simultaneous use of vanadium oxide and gold has meant a higher hydrogen production, higher in a 40% than that of the catalyst containing only vanadium oxide. This performance has been. related to the capacity of gold to activate CO in the water gas shift reaction. (C) 2015 Elsevier B.V. All rights reserved., The authors would like to acknowledge the DGICYT in Spain (CTQ2012-37925-C03-1, CTQ2012-37925-C03-2 and CTQ2012-37984-C02-01) for financial support We also thank the University of Valencia and SCSIE-UV for assistance. J.M. Lopez would also like to thank Spanish MICINN and CSIC for funding his Ramon y Cajal contract (RYC-2009-04483).
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Catalytic pyrolysis of wood biomass in an auger reactor using calcium-based catalysts

  • Veses Roda, Alberto
  • Aznar, María
  • Martínez Berges, Isabel
  • Martínez Ángel, Juan Daniel
  • López Sebastián, José Manuel
  • Navarro López, María Victoria
  • Callén Romero, M. Soledad
  • Murillo Villuendas, Ramón
  • García Martínez, Tomás
3 figures, 5 tables.-- Supplementary information available.--© 2014. This manuscript version is made available under the CC-BY-NC-ND 4.0 license https://creativecommons.org/licenses/by-nc-nd/4.0, Wood catalytic pyrolysis using calcium-based materials was studied in an auger reactor at 450 °C. Two different catalysts, CaO and CaO·MgO were evaluated and upgraded bio-oils were obtained in both cases. Whilst acidity and oxygen content remarkable decrease, both pH and calorific value increase with respect to the non-catalytic test. Upgrading process was linked to the fact that calcium-based materials could not only fix the CO2-like compounds but also promoted the dehydration reactions. In addition, process simulation demonstrated that the addition of these catalysts, especially CaO, could favour the energetic integration since a lowest circulation of heat carrier between combustor and auger reactor should be needed. An energy self-sustained system was obtained where thermal energy required for biomass drying and for pyrolysis reaction was supplied by non-condensable gas and char combustion, respectively., Authors thank to Spanish MINECO and European Union FEDER funds for providing support for this work (project CTQ2012-37984-C02-01). Authors also thank to Aragon Regional Government (DGA) and the Caixa Bank for partial financial support (Project GA-LC-015/2011). M. Aznar acknowledges the JAE-Doc Contract provided by European Social Found and CSIC. Financial support for I. Martínez during her PhD studies is provided by the FPU programme of the Spanish Ministry of Education (AP2009-3575). J.M. López would also like to thank Spanish MICINN and CSIC for founding his Ramon y Cajal contract (RYC-2009-04483). J.D. Martínez acknowledges to Departamento Administrativo de Ciencia, Tecnología e Innovación, (Colciencias), for his fellowship., Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Production of upgraded bio-oils by biomass catalytic pyrolysis in an auger reactor using low cost materials

  • Veses Roda, Alberto
  • Aznar, María
  • López Sebastián, José Manuel
  • Callén Romero, M. Soledad
  • Murillo Villuendas, Ramón
  • García Martínez, Tomás
2 figures, 3 tables.-- Supplementary information available.-- © 2014. This manuscript version is made available under the CC-BY-NC-ND 4.0 license https://creativecommons.org/licenses/by-nc-nd/4.0/, Production of upgraded bio-oils by catalytic pyrolysis of wood biomass was studied in an auger reactor using low cost materials as catalysts. These materials included several clay minerals (sepiolite, bentonite and attapulgite) and an industrial waste from alumina production, known as red mud. The influence of temperature (400–500 °C) and the effect of catalyst to biomass ratio (3:1–1:6, in weight) were also analysed. A temperature of 450 °C and the lowest catalyst proportion (1:6, in weight) were selected as the most appropriate to aim the pyrolysis for bio-oil production. Catalyst to biomass ratio resulted critical since an excess on catalyst addition seemed to reduce liquid production while char yield increased. Under the selected conditions, the catalysts tested improved the characteristics of the obtained bio-oil as fuel (viscosity, acidity, oxygen content and calorific value). For every catalyst, the viscosity of the organic liquid fraction decreased (up to 34% in case of bentonite) while lower heating value increased (up to 20% in red mud tests). Concerning acidity, sepiolite and red mud produced a decrease in the total acid number (around 29% and 23%, respectively). The stability of the organic fraction after aging test (equivalent to long time storage) was also improved by each catalyst., Authors thank to Spanish MINECO and European FEDER funds for providing support for this work (project CTQ2012-37984-C02-01). Authors also thank to Aragon Regional Government (DGA) and the Caixa Bank for partial financial support (Project GA-LC-015/2011). M. Aznar acknowledges the JAE-Doc Contract provided by European Social Found and CSIC. J.M. López would also like to thank Spanish MICINN and CSIC for funding his Ramon y Cajal contract (RYC-2009-04483), Peer reviewed
DIGITAL.CSIC. Repositorio Institucional del CSIC
Publicación Artículo científico (JournalArticle)

Thermodynamic analysis for syngas production from volatiles released in waste tire pyrolysis

  • Martínez Ángel, Juan Daniel
  • Murillo Villuendas, Ramón
  • García Martínez, Tomás
  • Arauzo, Inmaculada
15 figures, 4 tables.-- © 2014. This manuscript version is made available under the CC-BY-NC-ND 4.0 license https://creativecommons.org/licenses/by-nc-nd/4.0/, This paper shows the maximum limit on syngas composition obtained from volatiles released in waste tire pyrolysis when they are submitted to an air–steam partial oxidation process. Thus, from mass and energy balances and a stoichiometric equilibrium model, syngas composition and reaction temperature as well as some process parameters were predicted by varying both the equivalence ratio (ER) and the steam to fuel ratio (SF). In addition, pyrolysis experiments were performed using a continuous auger reactor, and the influence of pyrolysis temperature on composition of both volatiles and char was studied. Consequently, the resulting syngas characteristics were correlated with the pyrolysis temperature. The stoichiometric equilibrium model showed that an ER down to 0.4 is a practical limit to perform the air–steam partial oxidation process. When the process is carried out only with air, volatiles obtained at high pyrolysis temperature lead to lower reaction temperature and higher LHV of syngas in comparison with those found at low pyrolysis temperature. The H2 production is favored between 0.20 and 0.40 of ER and seems to be more influenced by the H/C ratio than by the water gas-shift reaction. On the other hand, the steam addition shows a more notable effect on the H2 production for volatiles obtained at the highest pyrolysis temperature (600 °C) in agreement with the lower reaction temperature under these experimental conditions. This thermodynamic analysis provides essential data on the optimization of syngas production from volatiles released in waste tire pyrolysis prior to run any test., This study has been carried out under the framework of the PET2008-0103 project financed by the Spanish Ministry of Science and Innovation. The authors would also like to thank MINECO and FEDER funds for providing partial support (project CTQ2012-37984-C02-01) as well as Aragon Regional Government (DGA). J.D. Martínez acknowledges to Departamento Administrativo de Ciencia, Tecnología e Innovación, COLCIENCIAS, for the fellowship., Peer reviewed
Zaguán. Repositorio Digital de la Universidad de Zaragoza
Publicación Artículo científico (JournalArticle)

In-situ synthesis of hydrogen peroxide in tandem with selective oxidation reactions: a review

  • Puértolas Lacambra, Begoña
  • Hill, Alf
  • García Martínez, Tomás
  • Solsona Espriú, Benjamín
  • Torrente Murciano, Laura
One-pot combination of the in-situ generation of hydrogen peroxide (H2O2) with selective oxidation reactions enhances the environmental and economic attractiveness of the use of H2O2 as green oxidant at industrial scale. This tandem reaction improves not only the safety aspects associated to H2O2 storage and transportation but also reduces the capital and operation costs. This review covers the progress in the field focussing on the areas of catalysis development, mechanistic understanding and engineering approaches (such as membrane reactors) for specific systems involving epoxidation of propylene oxide, hydroxylation of benzene, oxygenate synthesis from methane and Fenton processes, highlighting the main challenges to overcome in the near future.