Pasar al contenido principal

Resultados relacionados

Resultados totales (Incluyendo duplicados): 6
Encontrada(s) 1 página(s)

RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Vanadium Supported on Alumina and/or Zirconia Catalysts for the Selective Transformation of Ethane and Methanol

  • Benomar, S.
  • Masso Ramírez, Amada
  • Solsona Espriu, Benjamin Eduardo
  • Isaadi, R.
  • López Nieto, José Manuel|||0000-0002-6960-3219
[EN] Vanadium supported on pure (Al2O3, ZrO2) or mixed zirconia-alumina (with Al/(Al + Zr) ratio of 0.75 or 0.25) catalysts have been prepared by wet impregnation, using homemade prepared supports. The catalysts have been characterized and tested in the oxidative dehydrogenation (ODH) of ethane and in the methanol aerobic transformation. The catalytic performance strongly depends on the nature of the metal oxide support. Thus, activity decreases in the order: VOx/ZrO2 > VOx/(Al,Zr-oxides) > VOx/Al2O3. On the other hand, at low and medium ethane conversions, the selectivity to ethylene presents an opposite trend: VOx/Al2O3 > VOx/(Al,Zr-oxides) > VOx/ZrO2. The different selectivity to ethylene at high conversion is due to the lower/higher initial ethylene formation and to the extent of the ethylene decomposition. Interestingly, VOx/(Al,Zr-oxides) with low Zr-loading present the lowest ethylene decomposition. The catalytic results obtained mainly depend on the nature of the supports whereas the role of the dispersion of vanadium species is unclear. In methanol oxidation, the catalysts tested present similar catalytic activity regardless of the support (Al2O3, ZrO2 or mixed Al2O3-ZrO2) but strong differences in the selectivity to the reaction products. Thus, dimethyl ether was mainly observed on alumina-supported vanadium oxide catalysts (which is associated to the presence of acidic sites on the surface of the catalyst, as determined by TPD-NH3). Formaldehyde was the main reaction product on catalysts supported on Zr-containing oxides (which can be related to a low presence of acid sites). In this article, the importance of the presence of acid sites in ethane ODH, which can be estimated using the methanol transformation reaction, is also discussed., The authors would like to acknowledge the DGICYT (CTQ2015-68951-C3-1-R and MAT2017-84118-C2-1-R projects), the Secretary of State for International Cooperation in Spain (Project AP/040992/11) and FEDER for financial support. B.S. also thanks the University of Valencia (UV-INV-AE16-484416).
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Porous clays heterostructures as supports of iron oxide for environmental catalysis

  • Sanchis Martinez, Rut
  • Cecilia,J.A.
  • Vazquez, Isabel
  • Dejoz, Ana
  • Rodriguez-Castellon, E.
  • Solsona Espriu, Benjamin Eduardo
  • Soriano Rodríguez, Mª Dolores|||0000-0002-1799-895X
  • López Nieto, José Manuel|||0000-0002-6960-3219
[EN] Porous Clays Heterostructures (PCH) from natural pillared clays (bentonite with a high proportion of montmorillonite) have been used as supports of iron oxide for two reactions of environmental interest: i) the elimination of toluene (a representative compound of one of the most toxic subsets of volatile organic compounds, aromatics) by total oxidation and ii) the selective oxidation of H2S to elemental sulfur. For both reactions these catalysts have resulted to be remarkably more efficient than similar catalysts prepared using conventional silica as a support. Thus, in the total oxidation of toluene it has been observed that the catalytic activity obtained using siliceous PCH is two orders of magnitude higher than that with conventional silica. The catalytic activity has shown to be dependant of the capacity of the support for dispersing iron oxide in a way that the higher the dispersion of iron oxide on the surface of the support, the higher is the activity. In the case of the selective oxidation of H2S to S both higher catalytic activity and higher selectivity to S have been observed using siliceous porous clays heterostructures than using conventional silica. Highly dispersed FeOx species have been shown as highly selective towards elemental sulfur whereas more aggregated FeOx species favour the formation of sulphur oxides decreasing the selectivity to S. Analyses of the surface by XPS have shown the predominance of sulfate species in the catalysts presenting low selectivity to elemental sulfur., The authors would like to acknowledge the DGICYT in Spain (CTQ2015-68951-C3-1-R, CTQ2015-68951-C3-3-R, CTQ2012-37925-C03-2, CTQ2012-37925-C03-3 and CTQ2012-37984-C02-01) and FEDER for financial support. We also thank the University of Valencia for funding (UV-INV-AE-16-484416) and SCSIE-UV for assistance.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Ferric sludge derived from the process of water purification as an efficient catalyst and/or support for the removal of volatile organic compounds

  • Sanchis, Rut
  • Dejoz, Ana
  • Vázquez, Isabel
  • Vilarrasa-García, Enrique
  • Jiménez-Jiménez, José
  • Rodríguez-Castellón, Enrique
  • Solsona, Benjamín
  • López Nieto, José Manuel|||0000-0002-6960-3219
[EN] Ferric chloride solutions are used as coagulants or flocculants in water treatment operations for human consumption. This treatment produces large amounts of clay-type solids formed mainly of montmorillonite with iron oxides and humic substances. This ferric sludge can be used as an efficient catalyst for the removal of volatile organic compounds (VOCs) by total oxidation. This waste isolated in the purification process has been activated by calcinations in air, characterized by several physicochemical techniques and employed as a catalyst for the removal by total oxidation of representative VOCs: toluene, propane and mixtures of toluene/propane with or without water. This ferric sludge has shown a catalytic activity one order of magnitude higher than that of a commercial iron oxide. This high activity has been related to the composition of the sludge (as it contains active metal oxides such as oxides of iron and manganese) and to the porous structure (leading to a reasonably high surface area). Moreover, it can be also used as a support for platinum, showing comparable (or even higher) catalytic activity than a similar platinum catalyst supported on conventional gamma-alumina., The authors would like to acknowledge the DGICYT in Spain CTQ2012-37925-C03-2, CTQ2015-68951-C3-1-R and CTQ2015-68951-C3-3-R. Authors from UV thank the University of Valencia (UV-INV-AE16-484416 project) and MINECO (MAT2017-84118-C2-1-R project) for funding. Finally, authors thank the Electron Microscopy Service of SCSIE of Universitat de Valencia for their support.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

NiO diluted in high surface area TiO2 as efficient catalysts for the oxidative dehydrogenation of ethane

  • Sanchis, R.
  • Delgado-Muñoz, Daniel
  • Agouram, S.
  • Vázquez, M. I.
  • Rodriguez-Castellon, E.
  • Solsona, B.
  • Soriano Rodríguez, Mª Dolores|||0000-0002-1799-895X
  • López Nieto, José Manuel|||0000-0002-6960-3219
[EN] Catalysts consisting of NiO diluted in high surface area TiO2 can be as efficient in the oxidative dehydrogenation of ethane as the most selective NiO-promoted catalysts reported previously in the literature. By selecting the titania matrix and the NiO loading, yields to ethylene over 40% have been obtained. In the present article, three different titanium oxides (TiO2) have been employed as supports or diluters of nickel oxide and have been tested in the oxidative dehydrogenation of ethane to ethylene. All TiO2 used present anatase as the main crystalline phase and different surface areas of 11,55 and 85 m(2) g(-1). It has been observed that by selecting an appropriate nickel loading and the titanium oxide extremely high selectivity towards ethylene can be obtained. Thus, nickel oxide supported on TiO2 with high surface areas (i.e. 55 and 85 m(2) g(-1)) have resulted to give the best catalytic performance although the optimal nickel loading is different for each case. The optimal catalyst has been obtained for NiO-loadings up to 5-10 theoretical monolayers regardless of the TiO2 employed. Free TiO2 is inactive whereas unsupported NiO is active and unselective (forming mainly carbon dioxide) and, therefore, unmodified NiO particles have to be avoided in order to obtain the optimal catalytic performance. The use of low surface area titania (11 m(2) g(-1)) have led to the lowest selectivity to olefin due to the presence of an excess of free NiO particles. (C) 2017 Elsevier B.V. All rights reserved., The authors would like to acknowledge the DGICYT in Spain CTQ2012-37925-C03-2, CTQ2015-68951-C3-1-R, CTQ2015-68951-C3-3-R and SEV-2012-0267 Projects for financial support. D.D. also thanks Severo Ochoa Excellence fellowship (SVP-2014-068669). We also thank the University of Valencia (UV-INV-AE-16-484416 project) and SCSIE-UV for assistance
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Support effects on NiO-based catalysts for the oxidative dehydrogenation (ODH) of ethane

  • Delgado-Muñoz, Daniel
  • Sanchís, R.
  • Cecilia, J. A.
  • Rodríguez-Castellón, E.
  • Caballero, A.
  • Solsona, B.
  • López Nieto, José Manuel|||0000-0002-6960-3219
[EN] We report on the effect of NiO-support interactions on the chemical nature of Ni species in a series of supported NiO catalysts for the ODH of ethane. SiO2, TiO2-anatase, a high surface area TiO2 and a porous clay hetero-structure (PCH) with TiO2 and SiO2 pillars were used as supports, which led to a selectivity to ethylene in the range 30-90% over supported NiO catalysts. The catalysts were characterized by means of XRD, N-2-Adsorption, H-2-TPR, XPS and in situ (under H-2 reductive atmosphere) and ex situ XAS spectroscopy. The catalytic performance of supported materials is discussed in terms of their reducibility and specific reduction kinetics, but also taking into account the specific chemical nature of Ni species on each catalyst. The influence of the particle size and the presence of Ni and O vacancies on the catalytic performance in the ODH of ethane is inferred., Authors would like to thank the DGICYT in Spain CTQ2015-68951-C3-1-R, CTQ2015-68951-C3-3-R, CTQ2012-37925-C03-2 and ENE2017-88818-C2-1-R. Also authors want to acknowledge the ALBA Synchrotron Light Source (Project ID: 2015021258 at CLAESS beamline). Authors from ITQ thank Project SEV-2016-0683 for financial support. D. D. also thanks MINECO and Severo Ochoa Excellence Program for his fellowship (SVP-2014-068669). Authors from UV thank the University of Valencia (UV-INV-AE16-484416 project) and MINECO (MAT2017-84118-C2-1-R project) for funding.
RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia
Publicación Artículo científico (JournalArticle)

Redox and Catalytic Properties of Promoted NiO Catalysts for the Oxidative Dehydrogenation of Ethane

  • Delgado-Muñoz, Daniel
  • SOLSONA ESPRIU, BENJAMIN EDUARDO
  • Ykrelef, A.
  • Rodriguez-Gomez, A.
  • Caballero, A.
  • Rodríguez-Aguado, E.
  • Rodriguez-Castellón, E.
  • López Nieto, José Manuel|||0000-0002-6960-3219
[EN] NiO and metal-promoted NiO catalysts (M-NiO, with a M/(M+Ni) atomic ratio of 0.08, with M = Nb, Sn, or La) have been prepared, tested in the oxidative dehydrogenation (ODH) of ethane, and characterized by means of XRD, TPR, HRTEM, Raman, XPS, and in situ XAS (using H-2/He, air or C2H6/He mixtures). The selectivity to ethylene during the ODH of ethane decreases according to the following trend: Nb NiO Sn NiO > La NiO > NiO, whereas the catalyst reducibility (determined by both TPR and XAS using H-2/He mixtures) shows the opposite trend. However, different reducibility and catalytic behavior in the absence of oxygen (ethane/He mixtures) have been observed, especially when comparing Nb- and Sn-promoted NiO samples. These differences can be ascribed mainly to a different phase distribution of the promoter. The results presented here are discussed in terms of the nature of active and selective sites for ODH of ethane in selective and unselective catalysts, but also the role of promoters and the importance of their phase distribution., The authors would like to acknowledge the DGICYT in Spain CTQ2012-37925-C03-2, CTQ2015-68951-C3-1-R, and CTQ2015-68951-C3-3-R. Authors thank European Synchrotron Radiation Facility, ESRF (Project CH-4512; BM25-SpLine Beamlime). Authors from ITQ also thank Project SEV-2016-0683 for financial support. D.D. thanks MINECO and Severo Ochoa Excellence Program for his fellowship (SVP-2014-068669). B.S. also thanks UV-INV-AE16-484416. Finally, the authors thank the Electron Microscopy Service of Universitat Politecnica de Valencia for their support.