- Aparicio Esteve, Elena|||0000-0001-7886-312X
- Hernández Alonso, Álvaro|||0000-0001-9308-8133
- Ureña Ureña, Jesús|||0000-0003-1408-6039
- Villadangos Carrizo, José Manuel|||0000-0001-5900-0978
- Lluva Plaza, Sergio|||0000-0002-0050-2807
- Pérez Rubio, María del Carmen|||0000-0001-8271-6843
Nowadays, there is an increasing interest in smart systems, e.g., smart metering or smart
spaces, for which active sensing plays an important role. In such systems, the sample or
environment to be measured is irradiated with a signal (acoustic, infrared, radio‐frequency…) and
some of their features are determined from the transmitted or reflected part of the original signal.
In this work, infrared (IR) signals are emitted from different sources (four in this case) and received
by a unique quadrature angular diversity aperture (QADA) sensor. A code division multiple access
(CDMA) technique is used to deal with the simultaneous transmission of all the signals and their
separation (depending on the source) at the receiver’s processing stage. Furthermore, the use of
correlation techniques allows the receiver to determine the amount of energy received from each
transmitter, by quantifying the main correlation peaks. This technique can be used in any system
requiring active sensing; in the particular case of the IR positioning system presented here, the
relative amplitudes of those peaks are used to determine the central incidence point of the light from
each emitter on the QADA. The proposal tackles the typical phenomena, such as distortions caused
by the transducer impulse response, the near‐far effect in CDMA‐based systems, multipath
transmissions, the correlation degradation from non‐coherent demodulations, etc. Finally, for each
emitter, the angle of incidence on the QADA receiveris estimated, assuming that it is on a horizontal
plane, although with any rotation on the vertical axis Z. With the estimated angles and the known
positions of the LED emitters, the position (x, y, z) of the receiver is determined. The system is
validated at different positions in a volume of 3 × 3 × 3.4 m3 obtaining average errors of 7.1, 5.4, and
47.3 cm in the X, Y and Z axes, respectively., Agencia Estatal de Investigación, Universidad de Alcalá, Junta de Comunidades de Castilla-La Mancha